User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

Modes

Global Config

 

Interface Config

classofservice ip-precedence-mapping

This command maps an IP precedence value to an internal traffic class. The ipprecedence and trafficclass can both range from 0-7, although the actual number of available traffic classes depends on the platform. The 'no' form of this command is not supported.

Format

classofservice ip-precedence-mapping <ipprecedence>

 

<trafficclass>

Modes

Global Config

 

Interface Config

classofservice trust

This command sets the class of service trust mode of an interface. The mode can be set to trust one of the Dot1p (802.1p), IP Precedence, or IP DSCP packet markings.

Format

classofservice trust <dot1p/ip-precedence/ip-dscp>

Mode

Global Config

 

Interface Config

no classofservice trust

This command sets the interface mode to untrusted.

Format

no classofservice trust

Modes

Global Config

 

Interface Config

cos-queue max-bandwidth

This command specifies the maximum transmission bandwidth limit for each interface queue. Also known as rate shaping, this has the effect of smoothing temporary traffic bursts over time so that the transmitted traffic rate is bounded. The total number of queues supported per interface is platform specific.

Format

cos-queue

max-bandwidth <bw-0> <bw-1><bw-n>

Modes

Global Config

 

Interface

Config

Quality of Service (QoS) Commands

11-41

202-10088-01, March 2005

Page 303
Image 303
NETGEAR NETGEAR user manual Classofservice ip-precedence-mapping, Classofservice trust, Cos-queue max-bandwidth