NETGEAR NETGEAR Ip dhcp ping packets, Ip dhcp pool, No ip dhcp excluded-address, Defaultnone

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

Mode Global Config

no ip dhcp excluded-address

This command removes the excluded IP addresses for a DHCP client. Low-address and high- address are valid IP addresses; each made up of four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.

Format	no ip dhcp excluded-address <lowaddress> [highad-
	dress]
Mode	Global Config

ip dhcp ping packets

This command is used to specify the number, in a range from 2-10, of packets a DHCP server sends to a pool address as part of a ping operation. By default the number of packets sent to a pool address is 2(the smallest allowed number when sending packets). Setting the number of packets to 0 disables this command.

Note: The no form of this command sets the number of packets sent to a pool address to 0 and therefore prevents the server from pinging pool addresses.

Default	2
Format	ip dhcp ping packets <0,2-10>
Mode	Global Config
no ip dhcp ping packets

This command prevents the server from pinging pool addresses and sets the number of packets to 0.

Default	0
Format	no ip dhcp ping packets
Mode	Global Config

ip dhcp pool

This command configures a DHCP address pool name on a DHCP server and enters DHCP pool configuration mode.

Defaultnone

Switching Commands 8-85

202-10088-01, March 2005