NETGEAR NETGEAR user manual Quick Start up User Account Management, Quick Start up IP Address

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

Quick Start up User Account Management

Table 6-3.	Quick Start up User Account Management
Command		Details
show users		Displays all of the users that are allowed to access the switch
(in Privileged EXEC)
		Access Mode - Shows whether the user is able to change
		parameters on the switch(Read/Write) or is only able to view
		then (Read Only).
		As a factory default, admin has Read/Write access and guest
		has Read Only access. There can only be one Read/Write user
		and up to 5 Read Only users.
show loginsession		Displays all of the login session information
(in User EXEC)
users passwd <username>		Allows the user to set passwords or change passwords needed
(in Global Config)		to login
		A prompt will appear after the command is entered requesting
		the users old password. In the absence of an old password
		leave the area blank. The operator must press enter to execute
		the command.
		The system then prompts the user for a new password then a
		prompt to confirm the new password. If the new password and
		the confirmed password match a message will be displayed.
		User password should not be more than eight characters in
		length.
copy system:running-config		This will save passwords and all other changes to the device.
nvram:startup-config		If you do not save config, all configurations will be lost when a
(in Privileged EXEC)		power cycle is performed on the switch or when the switch is
		reset
logout		Logs the user out of the switch
(in User EXEC and Privileged
EXEC)

Quick Start up IP Address

To view the network parameters the operator can access the device by the following three methods.

•Simple Network Management Protocol - SNMP

•Telnet

•Web Browser

Quick Start up 6-3

202-10088-01, March 2005