NETGEAR NETGEAR Set igmp mcrtexpiretime, Set igmp fast-leave, No set igmp mcrtexpiretime

	User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Format	set igmp maxresponse <vlanId> <1-3599>
Mode	Vlan Mode

no set igmp maxresponse

This command sets the IGMP Maximum Response time on the VLAN to the default value.

Format	no set igmp maxresponse <vlanId>
Mode	Vlan Mode

set igmp mcrtexpiretime

This command sets the Multicast Router Present Expiration time on a particular VLAN. This is the amount of time in seconds that a switch will wait for a query to be received on an interface, which is participating in the VLAN, before the interface is removed from the list of interfaces with multicast routers attached. The range is 0 to 3600 seconds. A value of 0 indicates an infinite time- out, i.e. no expiration.

Default	0
Format	set igmp mcrtexpiretime <vlanId> <0-3600>
Mode	Vlan Mode

no set igmp mcrtexpiretime

This command sets the Multicast Router Present Expiration time on the VLAN to 0. A value of 0 indicates an infinite time-out, i.e. no expiration.

Format	no set igmp mcrtexpiretime <vlanId>
Mode	Vlan Mode

set igmp fast-leave

This command enables or disables IGMP Snooping fast-leave admin mode on a selected VLAN. Enabling fast-leave allows the switch to immediately remove the layer 2 LAN interface, participating in the VLAN, from its forwarding table entry upon receiving an IGMP leave message for that multicast group without first sending out MAC-based general queries to the interface.

Switching Commands 8-111

202-10088-01, March 2005