User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

tail-drop queue-parms <queue-id-1> [<queue-id-2><queue-id-n>] threshold <0-16> <0-16> <0-16>

no tail-drop queue-parms <queue-id-1> [<queue-id-2><queue-id-n>]

Modes

Global Config

 

Interface Config

traffic-shape

This command specifies the maximum transmission bandwidth limit for the interface as a whole. Also known as rate shaping, this has the effect of smoothing temporary traffic bursts over time so that the transmitted traffic rate is bounded. Use the 'no' form of this command to restore the default interface shaping rate value.

traffic-shape <bw> no traffic-shape

Modes

Global Config

 

Interface Config

show classofservice dot1p-mapping

This command displays the current Dot1p (802.1p) priority mapping to internal traffic classes for a specific interface. The slot/port parameter is optional and is only valid on platforms that support independent per-port class of service mappings. If specified, the 802.1p mapping table of the interface is displayed. If omitted, the most recent global configuration settings are displayed.

Format

show classofservice dot1p-mapping [slot/port]

Mode

Privileged EXEC

The following information is repeated for each user priority.

User Priority

The 802.1p user priority value.

Traffic Class

The traffic class internal queue identifier to which the user prior-

 

ity value is mapped.

Quality of Service (QoS) Commands

11-45

202-10088-01, March 2005

Page 307
Image 307
NETGEAR NETGEAR user manual Traffic-shape, Show classofservice dot1p-mapping