NETGEAR NETGEAR user manual Incompatibilities, Bandwidth percent, Class

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

Incompatibilities Expedite (all forms)

bandwidth percent

This command identifies a minimum amount of bandwidth to be reserved for the specified class instance within the named policy using a relative rate notation. The committed information rate is specified as a percentage of total link capacity and is an integer from 1 to 100.

Note: The actual bandwidth allocation does not occur until the policy is attached to an interface in a particular direction.

Note: The bandwidth kbps and percent commands are alternative ways to specify the same bandwidth policy attribute.

Format	bandwidth percent <1-100>
Mode	Policy-classmap Config
Restrictions	The sum of the committed information rate values for all band-
	width and expedite commands defined within a policy must not
	exceed the available link bandwidth of the interface to which that
	policy is assigned. Violation of this requirement shall prevent
	successful attachment of a policy to the interface, or shall cause
	this command to fail if the policy is already in service on one or
	more interfaces.
Policy Type	Out
Incompatibilities	Expedite (all forms)
class

This command creates an instance of a class definition within the specified policy for the purpose of defining treatment of the traffic class through subsequent policy attribute statements. The <classname> is the name of an existing DiffServ class. Note that this command causes the specified policy to create a reference to the class definition.

Note: The CLI mode is changed to Policy-classmap Config when this command is successfully executed.

Format	class <classname>
Mode	Policy-Map Config

Quality of Service (QoS) Commands 11-21

202-10088-01, March 2005