NETGEAR NETGEAR user manual Mark cos, Policy Type Mark ip-dscp

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

Note: The actual bandwidth allocation does not occur until the policy is attached to an interface in a particular direction.

Note: The expedite kbps and percent commands are alternative ways to specify the same expedite policy attribute.

Format	expedite percent <1-100> [1-128]
Mode	Policy-classmap Config
Restrictions	The sum of the committed information rate values for all band-
	width and expedite commands defined within a policy must not
	exceed the available link bandwidth of the interface to which that
	policy is assigned. Violation of this requirement shall prevent
	successful attachment of a policy to the interface, or shall cause
	this command to fail if the policy is already in service on one or
	more interfaces.
Policy Type	Out
Incompatibilities	Bandwidth (all forms), Shape Peak
mark cos

This command marks all packets for the associated traffic stream with the specified class of service value in the priority field of the 802.1p header. If the packet does not already contain this header, one is inserted. The CoS value is an integer from 0 to 7.

Default	1
Format	mark-cos <0-7>
Mode	Policy-classmap Config
Policy Type	In
mark ip-dscp

This command marks all packets for the associated traffic stream with the specified IP DSCP value.

The <dscpval> value is specified as either an integer from 0 to 63, or symbolically through one of the following keywords: af11, af12, af13, af21, af22, af23, af31, af32, af33, af41,

af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef.

Format	mark ip-dscp <dscpval>
Mode	Policy-classmap Config
Quality of Service (QoS) Commands		11-23

202-10088-01, March 2005