NETGEAR NETGEAR user manual Show serial, Show serviceport

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

Allow New Telnet Sessions Indicates that new telnet sessions will not be allowed when set to no. The factory default value is yes.

show serial

This command displays serial communication settings for the switch.

Format	show serial
Mode	Privileged EXEC and User EXEC

Serial Port Login Timeout (minutes) Specifies the time, in minutes, of inactivity on a

	Serial port connection, after which the Switch will close the con-
	nection. Any numeric value between 0 and 160 is allowed, the
	factory default is 5. A value of 0 disables the timeout.
Baud Rate	The default baud rate at which the serial port will try to connect.
	The available values are 1200, 2400, 4800, 9600, 19200,
	38400,57600, and 115200 baud. The factory Default is 9600
	baud.
Character Size	The number of bits in a character. The number of bits is always 8.
Flow Control	Whether Hardware Flow-Control is enabled or disabled. Hard-
	ware Flow Control is always disabled.
Stop Bits	The number of Stop bits per character. The number of Stop bits is
	always 1.
Parity Type	The Parity Method used on the Serial Port. The Parity Method is
	always None.

show serviceport

This command displays service port configuration information.

Format	show serviceport
Mode	Privileged EXEC
IP Address	The IP address of the interface. The factory default value is
	0.0.0.0
Subnet Mask	The IP subnet mask for this interface. The factory default value is
	0.0.0.0
Default Gateway	The default gateway for this IP interface. The factory default
	value is 0.0.0.0
8-26	Switching Commands

202-10088-01, March 2005