NETGEAR NETGEAR user manual Host, Ip dhcp excluded-address, No hardware-address, No host

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

Type indicates the protocol of the hardware platform. It is 1 for 10 MB Ethernet and 6 for IEEE 802.

Default	ethernet
Format	hardware-address<hardwareaddress> [type]
Mode	DHCP Pool Config
no hardware-address

This command removes the hardware address of the DHCP client.

Format	no hardware-address
Mode	DHCP Pool Config

host

This command specifies the IP address and network mask for a manual binding to a DHCP client. Address and Mask are valid IP addresses; each made up of four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.

The prefix-length is an integer from 0 to 32

Default	none
Format	host <address> [mask prefix-length]
Mode	DHCP Pool Config
no host

This command removes the IP address of the DHCP client.

Format	no host
Mode	DHCP Pool Config

ip dhcp excluded-address

This command specifies the IP addresses that a DHCP server should not assign to DHCP clients. Low-address and high-address are valid IP addresses; each made up of four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.

Default	none
Format	ip dhcp excluded-address<lowaddress> [highaddress]
8-84	Switching Commands

202-10088-01, March 2005