NETGEAR NETGEAR Dhcp Server Commands, Users snmpv3 encryption, No users snmpv3 encryption

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

users snmpv3 encryption

This command specifies the encryption protocol to be used for the specified login user. The valid encryption protocols are des or none.

If des is specified, the required key may be specified on the command line. The encryption key must be 8 to 64 characters long. If the des protocol is specified but a key is not provided, the user will be prompted for the key. When using the des protocol, the user login password is also used as the snmpv3 encryption password and therefore must be at least eight characters in length.

If none is specified, a key must not be provided. The <username> is the login user name associated with the specified encryption.

Default	no encryption
Format	users snmpv3 encryption <username> <none des[key]>
Mode	Global Config

no users snmpv3 encryption

This command sets the encryption protocol to none. The <username> is the login user name for which the specified encryption protocol will be used.

Format	no users snmpv3 encryption <username>
Mode	Global Config

DHCP Server Commands

These commands configure the DHCP Server parameters and address pools. The commands are divided by functionality into these different groups:

•Configuration Commands are used to configure features and options of the switch. For every configuration command there is a show command that will display the configuration setting.

•Show commands are used to display switch settings, statistics and other information.

•Clear commands clear some or all of the settings to factory defaults.

Switching Commands 8-81

202-10088-01, March 2005