NETGEAR NETGEAR user manual Simple Network Time Protocol Sntp, Sntp broadcast client poll-interval

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

Host Status	The state of logging to configured syslog hosts. If the status is
	disable, no logging occurs.

Simple Network Time Protocol (SNTP)

This section provides a detailed explanation of the SNTP commands. The commands are divided into two functional groups:

•Show commands display spanning tree settings, statistics, and other information.

•Configuration Commands configure features and options of the switch. For every configuration command there is a show command that displays the configuration setting.

sntp broadcast client poll-interval

This command will set the poll interval for SNTP broadcast clients in seconds as a power of two where <poll-interval> can be a value from 6 to 16.

Default	6
Format	sntp broadcast client poll-interval <poll-interval>
Mode	Global Config

no sntp broadcast client poll-interval

This command will reset the poll interval for SNTP broadcast client back to its default value.

Format	no sntp broadcast client poll-interval
Mode	Global Config

sntp client mode

This command will enable Simple Network Time Protocol (SNTP) client mode and optionally setting the mode to either broadcast, multicast, or unicast.

Default	Disabled
Format	sntp client mode [broadcast multicast unicast]
Mode	Global Config

8-72 Switching Commands

202-10088-01, March 2005