NETGEAR NETGEAR user manual Set prompt, Serviceport ip, Serviceport protocol, Show telnet, Modes

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

Mode Line Config

set prompt

This command changes the name of the prompt. The length of name may be up to 64 alphanumeric characters.

Format	set prompt	<prompt string>
Mode	Privileged	EXEC

serviceport ip

This command sets the IP address, the netmask and the gateway of the router.

Format	serviceport ip <ipaddr> <netmask> [gateway]
Mode	Privileged EXEC

serviceport protocol

This command specifies the servicePort configuration protocol. If you modify this value, the change takes effect immediately.

Format	serviceport protocol {none bootp dhcp}
Mode	Privileged EXEC

show telnet

This command displays the current outbound telnet settings.

Format	show telnet
Modes	Privileged EXEC
	User EXEC

Outbound Telnet Login Timeout (in minutes) Indicates the number of minutes an outbound telnet session is allowed to remain inactive before being logged off. A value of 0, which is the default, results in no timeout.

Maximum Number of Outbound Telnet Sessions Indicates the number of simultaneous outbound telnet connections allowed.

Switching Commands 8-23

202-10088-01, March 2005