NETGEAR NETGEAR Spanning-tree edgeport, Spanning-tree forceversion, No spanning-tree edgeport

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

no spanning-tree configuration revision

This command sets the Configuration Identifier Revision Level for use in identifying the configuration that this switch is currently using to the default value, i.e. 0.

Format	no spanning-tree configuration revision
Mode	Global Config

spanning-tree edgeport

This command specifies that this port is an Edge Port within the common and internal spanning tree. This will allow this port to transition to Forwarding State without delay.

Format	spanning-tree edgeport
Mode	Interface Config

no spanning-tree edgeport

This command specifies that this port is not an Edge Port within the common and internal spanning tree.

Format	no spanning-tree edgeport
Mode	Interface Config

spanning-tree forceversion

This command sets the Force Protocol Version parameter to a new value. The Force Protocol Version can be one of the following:

•802.1d - ST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1d functionality supported)

•802.1w - RST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1w functionality supported)

•802.1s - MST BPDUs are transmitted (IEEE 802.1s functionality supported)

Default	802.1s
Format	spanning-tree forceversion <802.1d 802.1w 802.1s>
Mode	Global Config
8-120	Switching Commands

202-10088-01, March 2005