NETGEAR NETGEAR user manual Telnet, Transport input telnet, No transport input telnet

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

•Show commands display switch settings, statistics, and other information.

•Configuration commands configure features and options of the switch. For every configuration command, there is a show command that displays the configuration setting.

telnet

This command establishes a new outbound telnet connection to a remote host. The host value must be a valid IP address. Valid values for port should be a valid decimal integer in the range of 0 to 65535, where the default value is 23. If [debug] is used, the current telnet options enabled is displayed. The optional line parameter sets the outbound telnet operational mode as ‘linemode’, where by default, the operational mode is ‘character mode’. The noecho option disables local echo.

Format	telnet <host> [port] [debug] [line] [noecho]
Modes	Privileged EXEC
	User EXEC

transport input telnet

This command regulates new telnet sessions. If sessions are enabled, new telnet sessions can be established until there are no more sessions available. If sessions are disabled, no new telnet sessions are established. An established session remains active until the session is ended or an abnormal network error ends the session.

Default	enabled
Format	transport input telnet
Mode	Line Config
no transport input telnet

This command disables telnet sessions. If sessions are disabled, no new telnet sessions are established.

Format	no transport input telnet
Mode	Line Config

8-16 Switching Commands

202-10088-01, March 2005