NETGEAR NETGEAR Ip route distance, Ip forwarding, No ip route default, No ip route distance

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

Format	ip route default <nextHopRtr> [<preference>]
Mode	Global Config
no ip route default

This command deletes all configured default routes. If the optional <nextHopRtr> parameter is designated, the specific next hop is deleted from the configured default route and if the optional preference value is designated, the preference of the configured default route is reset to its default.

Format	no ip route default [{<nextHopRtr> <preference>}]
Mode	Global Config

ip route distance

This command sets the default distance for static routes. Lower route preference values are preferred when determining the best route. The "ip route" and "ip route default" commands allow you to optionally set the distance of an individual static route. The default distance is used when no distance is specified in these commands. Changing the default distance does not update the distance of existing static routes, even if they were assigned the original default distance. The new default distance will only be applied to static routes created after invoking the "ip route distance" command.

Default	1
Format	ip route distance <1-255>
Mode	Global Config
no ip route distance

This command sets the default static route preference value in the router. Lower route preference values are preferred when determining the best route.

Format	no ip route distance
Mode	Global Config

ip forwarding

This command enables forwarding of IP frames.

Defaultenabled

Routing Commands 10-9

202-10088-01, March 2005