NETGEAR NETGEAR Set garp timer leave all, Set garp timer leaveall, No set garp timer leave all

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

Mode Interface Config

set garp timer leave all

This command sets the GVRP leave time for all ports. Leave time is the time to wait after receiving an unregister request for a VLAN or a multicast group before deleting the VLAN entry. This can be considered a buffer time for another station to assert registration for the same attribute in order to maintain uninterrupted service.time is 20 to 600 (centiseconds). The value 60 centiseconds is 0.6 seconds.

Note: This command has an effect only when GVRP is enabled.

Default	60
Format	set garp timer leave all <20-600>
Mode	Global Config
no set garp timer leave all

This command sets the GVRP leave time for all ports to the default 60 centiseconds (0.6 seconds).

Note: This command has an effect only when GVRP is enabled.

Format	no set	garp timer leave all
Mode	Global	Config

set garp timer leaveall

This command sets how frequently Leave All PDUs are generated per port. A Leave All PDU indicates that all registrations will be unregistered. Participants would need to rejoin in order to maintain registration. The value applies per port and per GARP participation. The time may range from 200 to 6000 (centiseconds). The value 1000 centiseconds is 10 seconds.

Note: This command has an effect only when GVRP is enabled.

Default	1000
Format	set garp timer leaveall <200-6000>
Mode	Interface Config
no set garp timer leaveall

This command sets how frequently Leave All PDUs are generated per port to 1000 centiseconds (10 seconds). .

8-98 Switching Commands

202-10088-01, March 2005