NETGEAR NETGEAR user manual Show snmptrap, Show trapflags

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

Access Mode	The access level for this community string.
Status	The status of this community access entry.

show snmptrap

This command displays SNMP trap receivers. Trap messages are sent across a network to an SNMP Network Manager. These messages alert the manager to events occurring within the switch or on the network. Six trap receivers are simultaneously supported.

Format	show snmptrap
Mode	Privileged EXEC
SNMP Trap Name	The community string of the SNMP trap packet sent to the trap
	manager. This may be up to 16 alphanumeric characters. This
	string is case sensitive.
IP Address	The IP address to receive SNMP traps from this device. Enter
	four numbers between 0 and 255 separated by periods.
Status	A pull down menu that indicates the receiver's status (enabled or
	disabled) and allows the administrator/user to perform actions on
	this user entry:
	Enable - send traps to the receiver
	Disable - do not send traps to the receiver.
	Delete - remove the table entry.

show trapflags

This command displays trap conditions. Configure which traps the switch should generate by enabling or disabling the trap condition. If a trap condition is enabled and the condition is detected, the switch's SNMP agent sends the trap to all enabled trap receivers. The switch does not have to be reset to implement the changes. Cold and warm start traps are always generated and cannot be disabled.

Format	show trapflags
Mode	Privileged EXEC
Authentication Flag	May be enabled or disabled. The factory default is enabled. Indi-
	cates whether authentication failure traps will be sent.
Link Up/Down Flag	May be enabled or disabled. The factory default is enabled. Indi-
	cates whether link status traps will be sent.
8-28	Switching Commands

202-10088-01, March 2005