NETGEAR NETGEAR user manual Storm-control flowcontrol, Show mac-address-table multicast

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

Table 2. Broadcast Storm Recovery Thresholds

Link Speed	High	Low
10M	20	10
100M	5	2
1000M	5	2
Format	no storm-control broadcast
Mode	Global Config

storm-control flowcontrol

This command enables 802.3x flow control for the switch.

Note: This command only applies to full-duplex mode ports.

Default	disabled
Format	storm-control flowcontrol
Mode	Global Config

no storm-control flowcontrol

This command disables 802.3x flow control for the switch.

Note: This command only applies to full-duplex mode ports.

Format	no storm-control flowcontrol
Mode	Global Config

show mac-address-table multicast

This command displays the Multicast Forwarding Database (MFDB) information. If the command is entered with no parameter, the entire table is displayed. This is the same as entering the optional all parameter. The user can display the table entry for one MAC Address by specifying the MAC address as an optional parameter.

Format	show mac-address-table multicast <macaddr all>
Mode	Privileged EXEC
Mac Address	A multicast MAC address for which the switch has forwarding and or filtering
	information. The format is two-digit hexadecimal numbers that are separated by
	colons, for example 01:23:45:67:89:AB. In an IVL system the MAC address
	will be displayed as a MAC address and VLAN ID combination of 8 bytes.
8-44	Switching Commands

202-10088-01, March 2005