NETGEAR NETGEAR user manual Vlan port tagging all, Vlan protocol group add protocol

	User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Format	no vlan port pvid all
Mode	Global Config

vlan port tagging all

This command configures the tagging behavior for all interfaces in a VLAN to enabled. If tagging is enabled, traffic is transmitted as tagged frames. If tagging is disabled, traffic is transmitted as untagged frames. The ID is a valid VLAN identification number.

Format	vlan port tagging all <1-4094>
Mode	Global Config
no vlan port tagging all

This command configures the tagging behavior for all interfaces in a VLAN to disabled. If tagging is disabled, traffic is transmitted as untagged frames. The ID is a valid VLAN identification number.

Format	no vlan port tagging all
Mode	Global Config

vlan protocol group

This command adds protocol-based VLAN group to the system. The <groupName> is a character string of 1 to 16 characters. When it is created, the protocol group will be assigned a unique number that will be used to identify the group in subsequent commands.

Format	vlan protocol	group <groupname>
Mode	Global Config

vlan protocol group add protocol

This command adds the <protocol> to the protocol-based VLAN identified by <groupid>. A group may have more than one protocol associated with it. Each interface and protocol combination can only be associated with one group. If adding a protocol to a group causes any conflicts with interfaces currently associated with the group, this command will fail and the protocol will not be added to the group. The possible values for protocol are ip, arp, and ipx.

Default	none
Format	vlan protocol group add protocol <groupid> <protocol>
Switching Commands	8-53

202-10088-01, March 2005