NETGEAR NETGEAR user manual Show users, Connection From, Idle Time, Session Time

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

	case sensitive. Two users are included as the factory default,
	‘admin’ and ‘guest’.
Connection From	IP address of the telnet client machine or EIA-232 for the serial
	port connection.
Idle Time	Time this session has been idle.
Session Time	Total time this session has been connected.

show users

This command displays the configured user names and their settings. This command is only available for users with Read/Write privileges. The SNMPv3 fields will only be displayed if SNMP is

available on the system.

Format	show users
Mode	Privileged EXEC
User Name	The name the user will use to login using the serial port, Telnet or
	Web. A new user may be added to the switch by entering a name
	in a blank entry. The user name may be up to eight characters, and
	is not case sensitive. Two users are included as the factory
	default, ‘admin’ and ‘guest’
Access Mode	Shows whether the operator is able to change parameters on the
	switch (Read/Write) or is only able to view them (Read Only). As
	a factory default, the ‘admin’ user has Read/Write access and the
	‘guest’ has Read Only access. There can only be one Read/Write
	user and up to five Read Only users.

SNMPv3 Access Mode This field displays the SNMPv3 Access Mode. If the value is set to ReadWrite, the SNMPv3 user will be able to set and retrieve parameters on the system. If the value is set to ReadOnly, the SNMPv3 user will only be able to retrieve parameter information. The SNMPv3 access mode may be different than the CLI and Web access mode.

SNMPv3 Authentication This field displays the authentication protocol to be used for the specified login user.

SNMPv3 Encryption This field displays the encryption protocol to be used for the specified login user.

8-78 Switching Commands

202-10088-01, March 2005