User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

no ip rip authentication

This command sets the default RIP Version 2 Authentication Type.

Format

no ip rip

authentication

Mode

Interface

Config

ip rip receive version

This command configures the interface to allow RIP control packets of the specified version(s) to be received.

The value for <mode> is one of: rip1 to receive only RIP version 1 formatted packets, rip2 for RIP version 2, both to receive packets from either format, or none to not allow any RIP control packets to be received.

Default

both

Format

ip rip receive version {rip1 rip2 both none}

Mode

Interface Config

no ip rip receive version

 

This command configures the interface to allow RIP control packets of the default version(s) to be received.

Format

no ip rip

receive version

Mode

Interface

Config

ip rip send version

This command configures the interface to allow RIP control packets of the specified version to be sent.

The value for <mode> is one of: rip1 to broadcast RIP version 1 formatted packets, rip1c (RIP version 1 compatibility mode) which sends RIP version 2 formatted packets via broadcast, rip2 for sending RIP version 2 using multicast, or none to not allow any RIP control packets to be sent.

Default

rip2

Format

ip rip send version {rip1 rip1c rip2 none}

Mode

Interface Config

 

 

10-26

Routing Commands

202-10088-01, March 2005

Page 258
Image 258
NETGEAR NETGEAR Ip rip receive version, Ip rip send version, No ip rip authentication, No ip rip receive version