ZyAIR B-2000 Wireless LAN Gateway with 4-Port Switch

3.The adjacent access points should use different radio channels when their coverage areas overlap.

4.All access points must use the same port number to relay roaming information.

5.The access points must be connected to the Ethernet and be able to get IP addresses from a DHCP server if using dynamic IP address assignment.

3.11.5 Enable the Roaming Feature on the ZyAIR

Enable the roaming feature if you have two or more ZyAIRs on the same subnet. Follow the steps below to allow roaming on your ZyAIR.

Step 1. From the main menu, enter 3 to display Menu 3 – LAN Setup. Step 2. Enter 5 to display Menu 3.5 – Wireless LAN Setup.

Menu 3.5 - Wireless LAN Setup

ESSID= Wireless

Hide ESSID= No

Channel ID= CH01 2412MHz

RTS Threshold= 2432

Frag. Threshold= 2432

WEP= Disable

Default Key= N/A

Key1= N/A

Key2= N/A

Key3= N/A

Key4= N/A

Edit MAC Address Filter= No

Edit Roaming Configuration= Yes

Press ENTER to Confirm or ESC to Cancel:

Figure 3-11 Wireless LAN Setup

Step 3. Move the cursor to the Edit Roaming Configuration field. Press [SPACE BAR] to select Yes and then press [ENTER]. Menu 3.5.2 – Roaming Configuration displays as shown next.

Menu 3.5.2 - Roaming Configuration

Active= Yes

Port #= 16290

Press ENTER to Confirm or ESC to Cancel:

Figure 3-12 Menu 3.5.2 – Roaming Configuration

The following table describes the fields in this menu.

3-18

Internet Access