ZyAIR B-2000 Wireless LAN Gateway with 4-Port Switch

You must press [ENTER] at the bottom of the screen to save the whole set. You must do this again if you make any changes to the set – including deleting a rule.

No changes to the set take place until this action is taken.

An End IP address must be numerically greater than its corresponding IP Start address.

If the Set Name field is left blank, the entire set will be deleted.

6.3.2Configuring Individual Rule

In Menu 15.1.1-Address Mapping Rules, select Edit in the Action field and then selecting a rule brings up the following menu, Menu 15.1.1.1 - Address Mapping Rule in which you can edit an individual rule and configure the Type, Local and Global Start/End IPs.

Menu 15.1.1.1 Address Mapping Rule

Type= One-to-One

Local IP:

Start=

End = N/A

Global IP:

Start=

End = N/A

Press ENTER to Confirm or ESC to Cancel:

Figure 6-9 Menu 15.1.1.1 - Editing/Configuring an Individual Rule in a Set Table 6-6 Menu 15.1.1.1 - Editing/Configuring an Individual Rule in a Set

FIELD

DESCRIPTION

EXAMPLE

 

 

 

Type

Press [SPACE BAR] and then [ENTER] to select from a total of five types.

One-to-One

 

These are the mapping types discussed in Table 6-2.Server allows you to

 

 

specify multiple servers of different types behind NAT to this computer.

 

 

See Section 6.5.3 for an example.

 

Local IP

Only local IP fields are N/A for server; Global IP fields MUST be set for

 

 

Server.

 

Start

This is the starting local IP address (ILA).

0.0.0.0

End

This is the ending local IP address (ILA). If the rule is for all local IPs, then

N/A

 

put the Start IP as 0.0.0.0 and the End IP as 255.255.255.255. This field is

 

 

N/A for One-to-One and Server types.

 

NAT

6-11