ZyAIR
Table
FIELD | DESCRIPTITON | EXAMPLE |
|
|
|
| Select SUA Only if you have just one public WAN IP address for your |
|
| ZyAIR. The SMT uses Address Mapping Set 255 (menu 15.1 - see |
|
| section 6.3.1). |
|
| Select None to disable NAT. |
|
|
|
|
Metric | The metric represents the “cost” of transmission for routing purposes. | 2 |
| IP routing uses hop count as the cost measurement, with a minimum of |
|
| 1 for directly connected networks. Type a number that approximates the |
|
| cost for this link. The number need not be precise, but it must be |
|
| between 1 and 15. In practice, 2 or 3 is usually a good number. |
|
|
|
|
Private | This determines if the ZyAIR will include the route to this remote node | No |
| in its RIP broadcasts. If set to Yes, this route is kept private and not |
|
| included in RIP broadcast. If No, the route to this remote node will be |
|
| propagated to other hosts through RIP broadcasts. |
|
|
|
|
RIP Direction | Press [SPACE BAR] and then [ENTER] to select the RIP Direction. | None |
| Options are Both, In Only, Out Only or None. |
|
Version | Press [SPACE BAR] and then [ENTER] to select the RIP version. | |
| Options are |
|
Multicast | None | |
| None disables IGMP. |
|
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
5.2Remote Node Filter
Move the cursor to the Edit Filter Sets field in menu 11.1, then press [SPACE BAR] to select Yes. Press [ENTER] to display Menu 11.5 - Remote Node Filter.
Use Menu 11.5 - Remote Node Filter to specify the filter set(s) to apply to the incoming and outgoing traffic between this remote node and the ZyAIR and also to prevent certain packets from triggering calls. You can specify up to 4 filter sets separated by comma, for example, 1, 5, 9, 12, in each filter field.
Note that spaces are accepted in this field.
Remote Node Configuration |