Chapter 15 Filters
Table 34 Access Management > Filter (IP/MAC) (continued)
LABEL | DESCRIPTION |
IP/MAC Filter Rule Index | Select the index number of the filter rule. |
|
|
Rule Type | Select IP or MAC type to configure the rule. |
| Use the IP Filter to block traffic by IP addresses. |
| Use the MAC Filter to block traffic by MAC address. |
|
|
Active | Use this field to enable or disable the rule. |
|
|
Source IP Address | Enter the source IP address of the packets you wish to filter. This field is |
| ignored if it is 0.0.0.0. |
|
|
Subnet Mask | Enter the IP subnet mask for the source IP address |
|
|
Port Number | Enter the source port of the packets that you wish to filter. The range of |
| this field is 0 to 65535. This field is ignored if it is 0. |
|
|
Destination IP Address | Enter the destination IP address of the packets you wish to filter. This |
| field is ignored if it is 0.0.0.0. |
|
|
Subnet Mask | Enter the IP subnet mask for the destination IP address. |
|
|
Port Number | Enter the destination port of the packets that you wish to filter. The range |
| of this field is 0 to 65535. This field is ignored if it is 0. |
|
|
Protocol | Select ICMP, TCP or UDP for the upper layer protocol. |
|
|
MAC Address | This field is only available when you select MAC in the Rule Type field. |
| Enter the MAC address of the packets you wish to filter. |
|
|
Rule Unmatched | Select the action for a packet not matching the rule. |
| Select Forward to forward traffic immediately and skip checking the |
| remaining rules. Select Next to check the next rule. |
|
|
IP/MAC Filter Listing |
|
|
|
IP/MAC Filter Set Index | Select the index number of the filter set from the |
|
|
Interface | This is the interface that the filter set applies to. |
|
|
Direction | The filter set applies to this traffic direction. |
|
|
# | This is the index number of the rule in a filter set. |
|
|
Active | This field shows whether the rule is activated. |
|
|
Src Address/Mask | This is the source IP address and subnet mask when you select IP as the |
| rule type. |
| This is the MAC address when you select MAC as the rule type. |
|
|
Dest IP/Mask | This is the destination IP address and subnet mask. |
|
|
Src Port | This is the source port number. |
|
|
Dest Port | This is the destination port number. |
|
|
Protocol | This is the upper layer protocol. |
|
|
Unmatched | When a packet doesn’t match the rule, this is the action the ZyXEL |
| Device takes on the packet. |
|
|
SAVE | Click this to save your changes. |
|
|
DELETE | Click this to remove the filter rule. |
|
|
CANCEL | Click this to restore your previously saved settings. |
|
|
| 111 |
|
|