ZyXEL Communications PLA450 Product Specifications and Wall- Mounting Instructions

The following tables summarize the ZyXEL Device’s hardware and firmware features.

Table 31 Hardware Features

Dimensions (W x D x H)	190 x 128 x 33 mm

Power Specification	120~240 VAC, 50/60 Hz

Ethernet port	Auto-negotiating:
	This auto-negotiation feature allows the ZyXEL Device to detect the speed
	of incoming transmissions and adjust appropriately without manual
	intervention. It allows data transfer of either 10 Mbps or 100 Mbps in either
	half-duplex or full-duplex mode depending on your Ethernet network.
	Auto-crossover:
	Use either crossover or straight-through Ethernet cables.

Reset Button	The reset button is built into the rear panel. Use this button to restore the
	ZyXEL Device to its factory default settings. Press for 1 second to restart
	the device. Press for 5 seconds to restore to factory default settings.

Antenna	The ZyXEL Device is equipped with a 2dBi detachable antenna to provide
	clear radio transmission and reception on the wireless network.

Operating Temperature	0º C ~ 40º C

Storage Temperature	-20º C ~ 60º C

Operation Humidity	20% ~ 90% RH (Non-condensing)

Storage Humidity	20% ~ 90% RH (Non-condensing)

Distance between the	115 mm
centers of the holes on
the device’s back.

Screw size for wall-	use M3 screws made of plastic (not included)
mounting

Table 32 Firmware Features

FEATURE	DESCRIPTION
Default IP Address	192.168.1.2

Default Subnet Mask	255.255.255.0 (24 bits)

Default Password	1234

DHCP Pool	192.168.1.33 to 192.168.1.64

Device Management	Use the web configurator to easily configure the rich range of features on
	the ZyXEL Device.