Chapter 3 Introducing the Web Configurator

3.3 Resetting the ZyXEL Device

If you forget your password or cannot access the web configurator, you will need to use the RESET button at the back of the ZyXEL Device to reload the factory-default configuration file. This means that you will lose all configurations that you had previously saved, and the password will be reset to “1234”.

3.3.1 Procedure to Use the Reset Button

1Make sure the PWR LED is on.

2Press the RESET button for ten seconds or until the PWR LED begins to blink and then release it. When the PWR LED begins to blink, the defaults have been restored and the ZyXEL Device restarts.

3.4Navigating the Web Configurator

The following summarizes how to navigate the web configurator from the Status screen.

3.4.1 The Status Screen

The following screen displays when you log into the ZyXEL Device.

"Not all screens are available when you select Basic mode (Table 30 on page 95 lists which screens are only available in Advanced mode). See the Configuration Mode field in the System Status box to check whether you are in Basic or Advanced mode. Use the Config Mode > General screen to change between modes.

 

37

PLA-450 User’s Guide