Chapter 3 Hardware Overview
1Insert the transceiver into the slot with the exposed section of PCB board facing down.
Figure 14 Transceiver Installation Example
2Press the transceiver firmly until it clicks into place.
3The Switch automatically detects the installed transceiver. Check the LEDs to verify that it is functioning properly.
Figure 15 Installed Transceiver
3.1.3.2 Transceiver Removal
Use the following steps to remove a transceiver (SFP or SFP+ module).
1Open the transceiver’s latch (latch styles vary).
Figure 16 Opening the Transceiver’s Latch Example
| 19 |
GS1910/XGS1910 Series User’s Guide | |
|
|