Husqvarna 324RX manual Assembly, Fitting the handlebar, Transport position, handlebar

Page 13

ASSEMBLY

ASSEMBLY

Fitting the handlebar

•Remove the screw at the rear of the throttle handle.

•Slide the throttle handle onto the right side of the handlebar, (see diagram).

•Align the screw hole in the throttle handle with the hole in the handlebar.

•Reﬁt the screw in the hole in the rear of the throttle handle.

•Screw the screw through the handle and handlebar. Tighten it.

•Unscrew the knob from the handlebar mounting.

•Position the handlebar as shown. Fit the mounting components and tighten the knob lightly.

•Put on the harness and hang the machine from the support hook. Now make a ﬁnal adjustment so that the machine is in a comfortable working position when it hangs from the harness. Tighten the knob.

Transport position, handlebar

•The handlebar can easily be turned to ﬁt along the shaft for easier transportation and storage.

•Loosen the knob. Turn the handlebar clockwise so that the throttle handle rests against the engine.

•Now twist the handlebar around the shaft. Tighten the knob.

•Fit the transport guard to the cutting attachment.

English – 13

Image 13

Contents Operator’s manual EPA 324RX-SeriesEnglish Symbols KEY TO SYMBOLSContents CONTENTSNote the following before starting Dear customer INTRODUCTIONWhat is what on the clearing saw? WHAT IS WHAT?Personal protective equipment GENERAL SAFETY PRECAUTIONSThrottle lockout Machine′s safety equipmentCutting attachment guard Stop switchVibration damping system Mufﬂer Quick releaseLocking nut Cutting equipmentCutting equipment Sharpening the saw blade Sharpening grass cutters and grass bladesGeneral rules WARNING! Always discard a blade that isTrimmer head Fitting the handlebar ASSEMBLYTransport position, handlebar Fitting a blade guard, grass blade and grass cutter Assembling the cutting equipmentFitting the blade guard and saw blade G F E DG F D B C Fitting a trimmer guard and Superauto II 1 trimmer headFitting other guards and cutting attachments Adjusting the harness and clearing sawStandard harness Correct balance Correct heightFuel handling FUEL HANDLINGFuel Fueling Check before starting STARTING AND STOPPINGStarting and stopping Warm engine WARNING! When the engine is started withFor throttle handles with a start throttle lock StartingGeneral working instructions WORKING TECHNIQUESThe ABC of clearing Forestry clearing using a saw blade Brush cutting with a saw blade Grass clearing using a grass bladeGrass trimming with a trimmer head TrimmingSweeping CuttingCarburetor MAINTENANCEMufﬂer Spark plug Cooling systemAir ﬁlter Cleaning the air ﬁlterBevel gear Oiling the air ﬁlterCheck that the bevel gear is ﬁlled three-quarters full with lubricant Maintenance scheduleTechnical data TECHNICAL DATAType Approved accessoriesCutting attachment guard, Art. no FEDERAL EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONSSuper Auto II Super Auto2,4 mm 4,0 mPage 10 cm 4,2 m 8,5 mClic 2,4-2,7 mm2,4-2,7 mm 4,25 m10 cm 4,3 m T35, T35xPage ´z+R=¶5I¨ ´z+R=¶5I¨