Husqvarna 324RX manual Maintenance, Oiling the air filter, Bevel gear

Page 29
Oiling the air filter

MAINTENANCE

Oiling the air filter

Always use HUSQVARNA filter oil, art. no. 531 00 92-48. The filter oil contains a solvent to make it spread evenly through the filter. You should therefore avoid skin contact.

Put the filter in a plastic bag and pour the filter oil over it. Knead the plastic bag to distribute the oil. Squeeze the excess oil out of the filter inside the plastic bag and pour off the excess before fitting the filter to the machine. Never use common engine oil. This would drain through the filter quite quickly and collect in the bottom.

Bevel gear

The bevel gear is filled with the right quantity of grease at the factory. However, before using the machine you should check that the bevel gear is filled three-quarters full with grease. Use HUSQVARNA special grease.

The grease in the bevel gear does not normally need to be changed except if repairs are carried out.

IMPORTANT! Use only HUSQVARNA replacement parts. Use of other brands of replacement parts can cause damage to your unit or injury to the operator or others.Your warranty does not cover damage or liability caused by the use of accessories and/or attachments not specifically recommended by HUSQVARNA.

English 29

Image 29
Contents English 324RX-SeriesOperator’s manual EPA Symbols KEY TO SYMBOLSNote the following before starting CONTENTSContents Dear customer INTRODUCTIONWhat is what on the clearing saw? WHAT IS WHAT?Personal protective equipment GENERAL SAFETY PRECAUTIONSThrottle lockout Machine′s safety equipmentVibration damping system Stop switchCutting attachment guard Muffler Quick releaseCutting equipment Cutting equipmentLocking nut Sharpening the saw blade Sharpening grass cutters and grass bladesGeneral rules WARNING! Always discard a blade that isTrimmer head Transport position, handlebar ASSEMBLYFitting the handlebar Fitting a blade guard, grass blade and grass cutter Assembling the cutting equipmentFitting the blade guard and saw blade G F E DG F D B C Fitting a trimmer guard and Superauto II 1 trimmer headStandard harness Adjusting the harness and clearing sawFitting other guards and cutting attachments Correct balance Correct heightFuel FUEL HANDLINGFuel handling Fueling Starting and stopping STARTING AND STOPPINGCheck before starting Warm engine WARNING! When the engine is started withFor throttle handles with a start throttle lock StartingGeneral working instructions WORKING TECHNIQUESThe ABC of clearing Forestry clearing using a saw blade Brush cutting with a saw blade Grass clearing using a grass bladeGrass trimming with a trimmer head TrimmingSweeping CuttingMuffler MAINTENANCECarburetor Spark plug Cooling systemAir filter Cleaning the air filterBevel gear Oiling the air filterCheck that the bevel gear is filled three-quarters full with lubricant Maintenance scheduleTechnical data TECHNICAL DATACutting attachment guard, Art. no Approved accessoriesType FEDERAL EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONSSuper Auto II Super Auto2,4 mm 4,0 mPage 10 cm 4,2 m 8,5 mClic 2,4-2,7 mm2,4-2,7 mm 4,25 m10 cm 4,3 m T35, T35xPage ´z+R=¶5I¨ ´z+R=¶5I¨