Husqvarna 324RX manual General Safety Precautions, Trimmer head

Page 12
Trimmer head

GENERAL SAFETY PRECAUTIONS

The filing angle is 15°. File alternate teeth to the right and those in between to the left. If the blade has been heavily pitted by stones it may be necessary to dress the top edges of the teeth with a flat file, in exceptional cases. If so, this should be done before filing with a round file. The top edges must be filed down by the same amount for all the teeth.

Adjust the blade setting. This should be 1 mm.

Trimmer head

IMPORTANT!

Always ensure the trimmer cord is wound tightly and evenly around the drum, otherwise the machine will generate harmful vibration.

Only use the recommended trimmer heads and trimmer cords. These have been tested by the manufacturer to suit a particular engine size. This is especially important when a fully automatic trimmer head is used. Only use the recommended cutting attachment. See the chapter on Technical data.

Smaller machines generally require small trimmer heads and vice versa. This is because when clearing using a cord the engine must throw out the cord radially from the trimmer head and overcome the resistance of the grass being cleared.

The length of the cord is also important. A longer cord requires greater engine power than a shorter cord of the same diameter.

Make sure that the cutter on the trimmer guard is intact. This is used to cut the cord to the correct length.

To increase the life of the cord it can be soaked in water for a couple of days. This will make the line tougher so that it lasts longer.

12 – English

Image 12
Contents 324RX-Series Operator’s manual EPAEnglish KEY TO SYMBOLS SymbolsCONTENTS ContentsNote the following before starting INTRODUCTION Dear customerWHAT IS WHAT? What is what on the clearing saw?GENERAL SAFETY PRECAUTIONS Personal protective equipmentMachine′s safety equipment Throttle lockoutStop switch Cutting attachment guardVibration damping system Quick release MufflerCutting equipment Locking nutCutting equipment Sharpening grass cutters and grass blades Sharpening the saw bladeGeneral rules WARNING! Always discard a blade that isTrimmer head ASSEMBLY Fitting the handlebarTransport position, handlebar Assembling the cutting equipment Fitting a blade guard, grass blade and grass cutterFitting the blade guard and saw blade G F E DFitting a trimmer guard and Superauto II 1 trimmer head G F D B CAdjusting the harness and clearing saw Fitting other guards and cutting attachmentsStandard harness Correct height Correct balanceFUEL HANDLING Fuel handlingFuel Fueling STARTING AND STOPPING Check before startingStarting and stopping WARNING! When the engine is started with Warm engineFor throttle handles with a start throttle lock StartingWORKING TECHNIQUES General working instructionsThe ABC of clearing Forestry clearing using a saw blade Grass clearing using a grass blade Brush cutting with a saw bladeGrass trimming with a trimmer head TrimmingCutting SweepingMAINTENANCE CarburetorMuffler Cooling system Spark plugAir filter Cleaning the air filterOiling the air filter Bevel gearMaintenance schedule Check that the bevel gear is filled three-quarters full with lubricantTECHNICAL DATA Technical dataApproved accessories TypeCutting attachment guard, Art. no YOUR WARRANTY RIGHTS AND OBLIGATIONS FEDERAL EMISSION CONTROL WARRANTY STATEMENTSuper Auto Super Auto II2,4 mm 4,0 mPage 8,5 m 10 cm 4,2 mClic 2,4-2,7 mm4,25 m 2,4-2,7 mmT35, T35x 10 cm 4,3 mPage ´z+R=¶5I¨ ´z+R=¶5I¨