TROUBLESHOOTING
WARNING: Unplug blower/sweeper from power source before servicing. Severe injury or death could occur from fire, electrical shock, or rotating impeller.
Note: For additional help, visit our technical service web site at www.remingtonpowertools.com.
ENGLISH
OBSERVED FAULT | POSSIBLE CAUSE | REMEDY | ||
Blower does not start when you slide | 1. | Battery not installed properly. | 1. | Verify proper installation of bat- |
the switch to the “on” position. |
|
|
| tery. |
| 2. | Battery not charged | 2. | Insure battery is charged per re- |
|
|
|
| quirements. |
Battery runs slowly. | 1. | Battery is nearly depleted. | 1. | Recharge battery completely. |
Battery discharges quickly. | 1. | Battery not fully charged. | 1. | Recharge battery completely. |
| 2. | Battery worn and will not hold | 2. | Replace battery. |
|
| a charge. |
|
|
Battery not charging. | 1. | Charger not plugged in. | 1. | Plug charger into 120V 60 Hz AC |
|
|
|
| source. |
| 2. | Battery not fully inserted into | 2. | Insure battery is inserted |
|
| charger base. |
| correctly in charger base. |
| 3. | Charger cord not properly connect- | 3. | Insure batter cord is fully in |
|
| ed to charger base. |
| inserted into charger base. |
| 4. | Charger damaged. | 4. | Replace charger. |
SAVE THESE INSTRUCTIONS
11 | www.remingtonpowertoolscom |