RedMax BCZ3000SW manual Transportation,  12 

Page 12

5. For safe operation

refill the tank of the unit in any place where there is a boiler, stove, wood fire, electrical sparks, welding sparks, or any other source of heat or fire which might ignite the fuel.

2.Never smoke while operating the unit or refilling its fuel tank.

3.When refilling the tank, always turn off the engine and allow it to cool down. Take a careful look around to make sure that there are no sparks or open flames anywhere nearby before refueling.

4.Wipe spilled fuel completely using a dry rag if any fuel spillage occurs during refueling.

5.After refueling, screw the fuel cap back tightly onto the fuel tank and then carry the unit to a spot 10feet (3m) or more away from where it was refueled before turning on the engine.

TRANSPORTATION

1.When hand-carrying the product, cover over the cutting part if necessary, lift up the product and carry it paying attention to the blade.

2.Never transport the product over rough roads over long distances by vehicle without removing all fuel from the fuel tank. If doing so, fuel might leak from the tank during transport.

12

Image 12
Contents BCZ3000SW BCZ3000SWPage Safety First ContentsSpecifications Parts location 4   5  Symbols on the machine  6 For safe operation Working ConditionWorking Circumstance  7 Working Plan  8 Before Starting the Engine Starting the Engine 9  Using the Product  10 Maintenance If Someone ComesHandling Fuel  11 Transportation  12  13  SE5 Mounting Engine SE5SE6 SE7 SE8 Putting on Waist PADInstalling Cutting Head SE10 SE9Balance Unit  15 HOW to MIX Fuel Fuel 16  Recommended Mixing Ratio Gasoline 50OILFueling the Unit For Your Engine LIFE, AvoidOperation OP1OP3 OP4 Starting Engine 19  Adjusting the Line Length OP7 20  Maintenance Maintenance ChartMA1 Refilling Trimming Line MA1  21  22  MA5 MA6 Muffler Spark ArresterGear Case MA6 Intake AIR Cooling VentProcedures to be Performed After Every 100 Hours of USE StorageMA8  24 Optional blade usage  25 OPT2 OPT3 SET UP the Blade StandardOPT4 OPT5OPT6 OPT7 OPT8 Cutting MethodOperation  27 OPT9  28 Controlling Blade Bounce Maintenance Blade OPT10Transporting the Unit  29 Troubleshooting guide Check Probable Causes Action 30  Parts list  31 Drive Unit BCZ3000S S/N 300001 and up  32 Optional Blade & Accessories  33 Drive Unit BCZ3000SW S/N 300001 and up  34  35   36   37  Part Number Description QtyManufacturer’s warranty coverage Limited Warranty RedMax Garantie limitée