RedMax BCZ3000S MA5 MA6 Muffler, Spark Arrester, Gear Case MA6, Intake AIR Cooling Vent,  23 

Page 23

9. Maintenance

MA5

(1)

MA6

MUFFLER

WARNING

Inspect periodically, the muffler for loose fasteners, any damage or corrosion. If any sign of exhaust leakage is found, stop using the machine and have it repaired immediately.

Note that failing to do so may result in the engine catching on fire.

SPARK ARRESTER

The muffler is equipped with a spark arrester to prevent red hot carbon from flying out of the exhaust outlet. Periodically inspect and clean as necessary with a wire brush. In the State of California it is required by law (Section 4442 of the California Public Resources Code) to equip a spark arrester when a gas powered tool is used in any forest covered, brush covered, or grass covered unimproved land. (MA5)

(1) spark arrester

GEAR CASE (MA6)

The reduction gears are lubricated by multipurpose, lithium-based grease in the gear case. Supply new grease every 25 hours of use or more often depending on the job condition.

Remove the side bolt in gearcase opposite of grease nipple before installing new grease to arrange for old grease to exit.

INTAKE AIR COOLING VENT

WARNING

Never touch the cylinder, muffler, or spark plugs with your bare hands immediately after stopping the engine. The engine can become very hot when in operation, and doing so could result in severe burns.

When checking the machine to make sure that it is okay before using it, check the area around the muffler and remove any wood chips or leaves which have attached themselves to the brushcutter. Failing to do so could cause the muffler to become overheated, and that this in turn could cause the engine to catch on fire. Always make

23

Image 23
Contents BCZ3000SW BCZ3000SWPage Contents Safety First 4  SpecificationsParts location  5   6  Symbols on the machine 7  For safe operationWorking Condition Working Circumstance 8  Working Plan 9  Before Starting the EngineStarting the Engine  10  Using the Product 11  MaintenanceIf Someone Comes Handling Fuel 12  Transportation 13  Putting on Waist PAD SE5Mounting Engine SE5 SE6 SE7 SE8 15  Installing Cutting Head SE10SE9 Balance UnitRecommended Mixing Ratio Gasoline 50OIL HOW to MIX FuelFuel  16 For Your Engine LIFE, Avoid Fueling the UnitOP4 Starting Engine OperationOP1 OP3 19   20  Adjusting the Line LengthOP7  21  MaintenanceMaintenance Chart MA1 Refilling Trimming Line MA1 22  Intake AIR Cooling Vent MA5 MA6 MufflerSpark Arrester Gear Case MA6 24  Procedures to be Performed After Every 100 Hours of USEStorage MA8 25  Optional blade usageOPT5 OPT2 OPT3 SET UP the BladeStandard OPT4 27  OPT6 OPT7 OPT8Cutting Method OperationControlling Blade Bounce OPT9 28   29  Maintenance BladeOPT10 Transporting the Unit 30  Troubleshooting guideCheck Probable Causes Action  31  Parts list 32  Drive Unit BCZ3000S S/N 300001 and up 33  Optional Blade & Accessories 34  Drive Unit BCZ3000SW S/N 300001 and up 35   36  Part Number Description Qty  37 Manufacturer’s warranty coverage Limited Warranty RedMax Garantie limitée