RedMax BCZ3000SW manual SE9, Installing Cutting Head SE10, Balance Unit,  15 

Page 15

6.Set up (BCZ3000S/BCZ3000SW)

SE9
(1)	(2)
SE10

SE11

■INSTALLING DEBRIS GUARD

•Put the debris guard on the gear box, attach it with the 2 screws. (SE9)

IMPORTANT

2 kinds of debris guard are packed in with BC3000SW. Choose the guard suitable for a cutting head. If the right guard is not used, it may lead to a serious accident. (SE9)

(1)Guard for Line Head (Red) (848-JC0-6610)

(2)Guard for Blade (Black) (T3246-24110)

■INSTALLING CUTTING HEAD (SE10)

1.While locking the gear shaft, by inserting the supplied tool into the upper holder on the gear box, loosen and remove the hexagon nut(left- handed)

2.Fit the holder attached to the upper holder. Then screw in the cutting head to the gear shaft over the holders. Hand-tighten it securely.

IMPORTANT

You need not holder (B) and nut when installing the cutting head.

■BALANCE UNIT

1.Put on strap and attach unit to strap.

2.Slide clamp up or down until unit balances with head just touching on the ground. (SE11)

15 

Image 15

Contents BCZ3000SW BCZ3000SWPage Contents Safety FirstSpecifications Parts location 4   5   6  Symbols on the machine 7  For safe operationWorking Condition Working Circumstance 8  Working PlanBefore Starting the Engine Starting the Engine 9   10  Using the Product 11  MaintenanceIf Someone Comes Handling Fuel  12  Transportation 13  Putting on Waist PAD SE5Mounting Engine SE5 SE6 SE7 SE8 15  Installing Cutting Head SE10SE9 Balance UnitRecommended Mixing Ratio Gasoline 50OIL HOW to MIX FuelFuel  16 For Your Engine LIFE, Avoid Fueling the UnitOP4 Starting Engine OperationOP1 OP3 19  Adjusting the Line Length OP7 20   21  MaintenanceMaintenance Chart MA1 Refilling Trimming Line MA1 22  Intake AIR Cooling Vent MA5 MA6 MufflerSpark Arrester Gear Case MA6 24  Procedures to be Performed After Every 100 Hours of USEStorage MA8 25  Optional blade usageOPT5 OPT2 OPT3 SET UP the BladeStandard OPT4 27  OPT6 OPT7 OPT8Cutting Method OperationOPT9  28 Controlling Blade Bounce  29  Maintenance BladeOPT10 Transporting the UnitTroubleshooting guide Check Probable Causes Action 30   31  Parts list 32  Drive Unit BCZ3000S S/N 300001 and up 33  Optional Blade & Accessories 34  Drive Unit BCZ3000SW S/N 300001 and up 35   36  Part Number Description Qty  37 Manufacturer’s warranty coverage Limited Warranty RedMax Garantie limitée