RedMax BCZ3000SW manual Fueling the Unit, For Your Engine LIFE, Avoid

Page 17

7. Fuel

again for at least one minute. As some oils may be difficult to agitate depending on oil ingredients, sufficient agitation is necessary for the engine to last long. Be careful that, if the agitation is insufficient, there is an increased danger of early piston seizing due to abnormally lean mixture.

5.Put a clear indication on the outside of the container to avoid mixing up with gasoline or other containers.

6.Indicate the contents on outside of container for easy identification.

FUELING THE UNIT

1.Untwist and remove the fuel cap. Rest the cap on a dustless place.

2.Put fuel into the fuel tank to 80% of the full capacity.

3.Fasten the fuel cap securely and wipe up any fuel spillage around the unit.

WARNING

1.Select bare ground for fueling.

2.Move at least 10feet (3meters) away from the fueling point before starting the engine.

3.Stop the engine before refueling the unit. At that time, be sure to sufficiently agitate the mixed gasoline in the container.

FOR YOUR ENGINE LIFE, AVOID;

1.FUEL WITH NO OIL(RAW GASOLINE) – It will cause severe damage to the internal engine parts very quickly.

2.GASOHOL – It can cause deterioration of rubber and/or plastic parts and disruption of engine lubrication.

3.OIL FOR 4-CYCLE ENGINE USE – It can cause spark plug fouling, exhaust port blocking, or piston ring sticking.

4.Mixed fuels which have been left unused for a period of one month or more may clog the carburetor and result in the engine failing to operate properly.

5.In the case of storing the product for a

long period of time, clean the fuel tank after rendering it empty. Next, activate the engine and empty the carburetor of the composite fuel.

6.In the case of scrapping the used mixed oil container, scrap it only at an authorized repository site.

NOTE

As lot details of quality assurance, read the description in the section Limited Warranty carefully. Moreover, normal wear and change in product with no functional influence are not covered by the warranty. Also, be careful that, if the usage in the instruction manual is not observed as to fhe mixed gasoline, etc. described therein, it may not be covered by the warranty.

17

Image 17
Contents BCZ3000SW BCZ3000SWPage Contents Safety First 4  SpecificationsParts location  5   6  Symbols on the machineWorking Condition For safe operationWorking Circumstance  7  8  Working Plan 9  Before Starting the EngineStarting the Engine  10  Using the ProductIf Someone Comes MaintenanceHandling Fuel  11  12  Transportation 13  Mounting Engine SE5 SE5SE6 SE7 SE8 Putting on Waist PADSE9 Installing Cutting Head SE10Balance Unit  15 Fuel HOW to MIX Fuel 16  Recommended Mixing Ratio Gasoline 50OILFor Your Engine LIFE, Avoid Fueling the UnitOP1 OperationOP3 OP4 Starting Engine 19   20  Adjusting the Line LengthOP7 Maintenance Chart MaintenanceMA1 Refilling Trimming Line MA1  21  22  Spark Arrester MA5 MA6 MufflerGear Case MA6 Intake AIR Cooling VentStorage Procedures to be Performed After Every 100 Hours of USEMA8  24  25  Optional blade usageStandard OPT2 OPT3 SET UP the BladeOPT4 OPT5Cutting Method OPT6 OPT7 OPT8Operation  27 Controlling Blade Bounce OPT9 28  OPT10 Maintenance BladeTransporting the Unit  29  30  Troubleshooting guideCheck Probable Causes Action  31  Parts list 32  Drive Unit BCZ3000S S/N 300001 and up 33  Optional Blade & Accessories 34  Drive Unit BCZ3000SW S/N 300001 and up 35   36  Part Number Description Qty  37 Manufacturer’s warranty coverage Limited Warranty RedMax Garantie limitée