11. Optional blade usage
OPT6
OPT7
OPT8
started by putting the throttle into the start position. When starting the engine, place the product onto the ground in a flat clear area and hold it firmly in place so as to ensure that neither the cutting part nor the throttle come into contact with any obstacle when the engine starts. (OPT6)
■CUTTING METHOD
a)Use the front left side cutting.
b)Guide the blade from your right to left with it tilted slightly to your left. (OPT7)
c)When mowing a wide area, start working from your left end to avoid interference of cut grass.
d)The blade may be seized by weeds if the engine speed is too low, or the blade cuts too deep into weeds. Adjust the engine speed and cutting depth according to the condition of object.
WARNING
•If the grass or other object gets caught in the blade, or if the unit starts to shake or vibrate, turn off the engine and check the whole unit. Change the blade if it has been damaged.
•Turn off the engine and make sure the blade has completely stop before checking the blade, and removing any object got caught in.
■OPERATION
1.Check the bolt to fasten the blade and be sure the bolt has no fault, and no abrasion.
2.Be sure that the blade and the holder have been fastened according to instruction and the blade turns smoothly without abnormal noise. (OPT8)
WARNING
•The rotating parts fastened incorrectly may cause serious accident to the operator.
•Make sure that the blade is not bent, warped, cracked, broken or damaged.
•If you find any error to the blade, discard it and change new one which is certified by RedMax.