RedMax BCZ3000SW manual Manufacturer’s warranty coverage

Page 38

CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT

YOUR WARRANTY RIGHTS AND OBLIGATIONS

The California Air Resources Board and KOMATSU ZENOAH are pleased to explain the emission control system warranty on your 1995 and later small off-road engine. In California, new small off-road engines must be designed, built and equipped to meet the state’s stringent anti-smog standards. KOMATSU ZENOAH must warrant the emission control system on your small off-road engine for the periods of time listed below provided there has been no abuse, neglect or improper maintenance of your small off-road engine.

Your emission control system may include parts such as the carburetor and the ignition system.

Where a warrantable condition exists, KOMATSU ZENOAH will repair your small off-road engine at no cost to you including diagnosis, parts and labor.

Manufacturer’s warranty coverage:

The 1995 and later small off-road engines are warranted for two years. If any emission- related part on your engine is defective, the part will be repaired or replaced by

KOMATSU ZENOAH.

Owner’s warranty responsibilities:

As the small off-road engine owner, you are responsible for the performance of the required maintenance listed in your owner’s manual. KOMATSU ZENOAH recommends that you retain all receipts covering maintenance on your small off-road engine, but KOMATSU ZENOAH can not deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance.

As the small off-road engine owner, you should be aware, however, that KOMATSU ZENOAH may deny you warranty coverage if your small off-road engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modification.

You are responsible for presenting your small off-road engine to a KOMATSU ZENOAH distribution center as soon as a problem exists. The warranty repairs should be completed in e reasonable amount of time, not to exceed 30 days.

If you have any questions regarding your warranty rights and responsibilities, you should contact KOMATSU ZENOAH AMERICA INC. at (770)-381-5147 or you can write to

KOMATSU ZENOAH AMERICA INC.

4344 Shackleford Road Suite 500

Norcross, Georgia 30093

Image 38
Contents BCZ3000SW BCZ3000SWPage Safety First Contents 4  SpecificationsParts location  5  Symbols on the machine  6 Working Circumstance For safe operationWorking Condition  7 Working Plan  8  9  Before Starting the EngineStarting the Engine Using the Product  10 Handling Fuel MaintenanceIf Someone Comes  11 Transportation  12  13  SE6 SE7 SE8 SE5Mounting Engine SE5 Putting on Waist PADBalance Unit Installing Cutting Head SE10SE9  15  16  HOW to MIX FuelFuel Recommended Mixing Ratio Gasoline 50OILFueling the Unit For Your Engine LIFE, AvoidOP3 OperationOP1 OP4 Starting Engine 19   20  Adjusting the Line LengthOP7 MA1 Refilling Trimming Line MA1 MaintenanceMaintenance Chart  21  22  Gear Case MA6 MA5 MA6 MufflerSpark Arrester Intake AIR Cooling VentMA8 Procedures to be Performed After Every 100 Hours of USEStorage  24 Optional blade usage  25 OPT4 OPT2 OPT3 SET UP the BladeStandard OPT5Operation OPT6 OPT7 OPT8Cutting Method  27 Controlling Blade Bounce OPT9 28  Transporting the Unit Maintenance BladeOPT10  29  30  Troubleshooting guideCheck Probable Causes Action Parts list  31 Drive Unit BCZ3000S S/N 300001 and up  32 Optional Blade & Accessories  33 Drive Unit BCZ3000SW S/N 300001 and up  34  35   36   37  Part Number Description QtyManufacturer’s warranty coverage Limited Warranty RedMax Garantie limitée