RedMax BCZ3000SW manual Mounting Engine SE5, SE6 SE7 SE8, Putting on Waist PAD,  14 

Page 14

6.Set up (BCZ3000SW)

SE5

■MOUNTING ENGINE (SE5)

1.Push the driveshaft housing toward the clutch housing and rotate it by hand to check that the driveshaft is engaged with the gears.

2.Insert the driveshaft housing into the clutch housing until it bottoms, and align the positioning holes on the clutch housing and the shaft tube and install the screw. When difficult to engage, twist the engine slightly.

3.Fasten the clamp securely with two screws.

SE6

SE7

SE8

(1)

IMPORTANT

Tighten the screws gradually by turns.

■INSTALLING HANDLE

•Mount the handle to the shaft tube and clamp it at a location that is comfortable to you. (SE6)

(1) About 14.5 inches (37cm)

■CONNECTING THROTTLE WIRE

1. Remove the air cleaner cover.

2. Connect the end of the throttle wire to the joint on the top of the carburetor. (SE7)

■CONNECTING SWITCH WIRES

1.Connect the switch wires between the engine and the main unit. Pair the wires of the same color. (SE7)

2.Insert the terminal in the clamp.

■PUTTING ON WAIST PAD

• Fix the tube by the band. (SE8)

(1) Band

14 

Image 14

Contents BCZ3000SW BCZ3000SWPage Safety First Contents 4  SpecificationsParts location  5  Symbols on the machine  6 Working Circumstance For safe operationWorking Condition  7 Working Plan  8  9  Before Starting the EngineStarting the Engine Using the Product  10 Handling Fuel MaintenanceIf Someone Comes  11 Transportation  12  13  SE6 SE7 SE8 SE5Mounting Engine SE5 Putting on Waist PADBalance Unit Installing Cutting Head SE10SE9  15  16  HOW to MIX FuelFuel Recommended Mixing Ratio Gasoline 50OILFueling the Unit For Your Engine LIFE, AvoidOP3 OperationOP1 OP4 Starting Engine 19   20  Adjusting the Line LengthOP7 MA1 Refilling Trimming Line MA1 MaintenanceMaintenance Chart  21  22  Gear Case MA6 MA5 MA6 MufflerSpark Arrester Intake AIR Cooling VentMA8 Procedures to be Performed After Every 100 Hours of USEStorage  24 Optional blade usage  25 OPT4 OPT2 OPT3 SET UP the BladeStandard OPT5Operation OPT6 OPT7 OPT8Cutting Method  27 Controlling Blade Bounce OPT9 28  Transporting the Unit Maintenance BladeOPT10  29  30  Troubleshooting guideCheck Probable Causes Action Parts list  31 Drive Unit BCZ3000S S/N 300001 and up  32 Optional Blade & Accessories  33 Drive Unit BCZ3000SW S/N 300001 and up  34  35   36   37  Part Number Description QtyManufacturer’s warranty coverage Limited Warranty RedMax Garantie limitée