Simplicity Cobalt Series manual Ignition Switch, Throttle Control, Ground Speed Control Levers

Page 17

Ignition Switch

The ignition switch starts and stops the engine, it has three positions:

OFF

Stops the engine and shuts off the

 

electrical system.

RUN

Allows the engine to run and powers the

 

electrical system.

START

Cranks the engine for starting

NOTE: Never leave the ignition switch in the RUN position with the engine stopped-this drains the battery.

Throttle Control

The throttle controls engine speed. Move the throttle forward to increase engine speed and back to decrease engine speed. Always operate at FULL throttle

Ground Speed Control Levers

These levers control the ground speed of the rider. The left lever controls the left rear drive wheel and the right lever controls the right rear drive wheel.

Moving a lever forward increases the FORWARD speed of the associated wheel, and pulling back on a lever increases the REVERSE speed.

Note: The further a lever is moved away from the neutral position the faster the drive wheel will turn.

See the Operating the Zero Turn Rider section for steering instructions.

Headlight

The headlight switch turns the headlights on and off.

Hour Meter / Maintenance Reminder

Measures the time of the PTO being engaged. The hour meter measures the number of hours the PTO has been engaged. The hour meter will flash an initial oil change indicator at 5 hours, and a lubrication reminder every 50 hours. These reminders display for approximately two hours and will automatically reset themselves.

Note: The hour meter will register the passage of time only when the PTO is engaged. The hour meter has a self contained power source so the total hours are always visible.

Features and Controls

Seat Adjustment Lever

The seat can be adjusted forward and back. Move the lever towards the left, position the seat as desired, and release the lever to lock the seat in position.

Fuel Tank Cap

To remove the cap, turn counterclockwise.

Fuel Level Gauge

Displays the fuel level in the tank.

Retractable Seat Belt

The seat belt is used to secure the operator to the seat.

The seat belt should always be worn when the Roll Bar is in the raised position. The seat belt should never be worn when the Roll Bar is in the down position.

Safety

Controls

Operation

Maintenance Troubleshooting Specifications

15

Page 16 Page 18
Image 17
Page 16 Page 18
Contents 5900763 30HP Zero-Turn Riders Mfg. No DescriptionDate Purchased Table of Contents Operating Safety Operator SafetyRead the Manual ChildrenMoving Parts Slope OperationThrown Objects Overhead Obstacles Roll Bar UseRetaining Walls, Drop-offs, and Water Enclosed Areas Fuel and MaintenanceControls Operation Troubleshooting Maintenance SafetySpecifications General OperationEmissions Towed Equipment Ride-On UnitsIgnition System Operating on steep slopes can be dangerousSafe Handling of Gasoline Service and MaintenanceService & Maintenance Inspection of the Roll Bar Protective Structure Roll Bar InstructionsOperational Warnings Inspection and Maintenance of the Roll Bar Seat Belt Safety Decals Safety Controls OperationOperational Safety Checks Safety Interlock SystemSafety Icons North American Safety IconsIdentification Numbers Features and ControlsCE Models CE Identification Tag MarkingsTroubleshooting Safety Controls Operation MaintenancePTO Power Take Off Switch Parking BrakeHour Meter / Maintenance Reminder Ignition SwitchSeat Adjustment Lever Throttle ControlChecks Before Starting General Operating SafetyOperation Check Tire Pressures Seat AdjustmentPushing the Rider by Hand Tire PressureTo Adjust Pedal Position Mowing Height AdjustmentFoot Pedal Adjustment Stopping the Rider Insert the key into the ignition switch and turn it toStarting the Engine Forward Travel Practice Zero-Turn Driving PracticeSmooth Travel Reverse Travel PracticePractice Turning In Place Practice Turning Around a CornerExecuting an End-Of-Row Zero Turn TurningRaise and Lower the Roll Bar Specifications TroubleshootingTo Lower the Roll Bar To Raise the Roll BarMowing Recommendations MowingHeight of Grass Tall Grass Requires Incremental CuttingMowing Methods Proper Mulching Attaching a TrailerMulching Requires Excellent Mowing Conditions How Much Grass to MulchCheck Rider / Mower for loose hardware Regular MaintenanceMaintenance Schedule Fuel Filter Checking / Adding FuelChange Oil & Filter Remove the shop cloth and wipe up any spilled oilChange Interval Every 250 Hours Filter Part Number Change Hydraulic Oil FilterCheck Hydraulic Oil Level Grease LubricationOil Lubricating the Front CastersServicing The Mower Blades Safety Controls Operation Troubleshooting MaintenanceInspecting the Mower Blades Never weld or straighten bent mower bladesSpecifications Reinstalling the Mower BladesBattery Maintenance Battery ChargingCleaning the Battery and Cables Keep open flames and sparks away from the batterySpeed Balancing Adjustment Ground Speed Control Lever AdjustmentReturn-to-Neutral Adjustment Neutral AdjustmentChecking the Adjustment AdjustmentHydraulic Pump Drive Belt Replacement Parking Brake AdjustmentTo adjust the spring pre-load Suspension AdjustmentSpring loaded components can kick back causing injury To adjust the upper mounting position Rear ShocksDeck Lift Rod Timing Adjustment Deck Lift Spring Regular MaintenanceTo avoid damaging belts, do not pry belts over pulleys Mower Belt ReplacementSafety Controls TroubleshootingOperation Specifications Troubleshooting Maintenance Troubleshooting the RiderTroubleshooting the Mower Troubleshooting the RiderTroubleshooting Common Cutting Problems Operation MaintenanceTechnical Manuals SpecificationsControls Operation HP Briggs & StrattonOperation Controls Safety This page Intentionally Blank Belts and Blades Product Quick Specs

Cobalt Series specifications

The Simplicity Cobalt Series is an innovative line of gardening equipment that blends performance, durability, and ease of use. Designed for both amateur gardeners and seasoned professionals, the Cobalt Series reflects a commitment to cutting-edge technology and thoughtful design, making garden maintenance enjoyable and efficient.

One of the standout features of the Cobalt Series is its lightweight yet robust construction. Utilizing advanced materials, these tools minimize user fatigue, allowing for prolonged usage without discomfort. The ergonomic design of the handles ensures a comfortable grip, promoting natural hand movements which reduces strain during gardening tasks.

The Cobalt Series integrates smart technology into its product lineup. Many of the tools are equipped with a unique power management system, optimizing battery life and enhancing efficiency. This means users can accomplish more with less time spent recharging. Additionally, select models feature wireless connectivity, allowing gardeners to track their usage, receive maintenance reminders, and access instructional content through a dedicated app.

A key characteristic of the Cobalt Series is versatility. The range includes a variety of tools such as electric trimmers, mowers, and blowers, all designed to tackle different gardening tasks with ease. Each tool is engineered for optimal performance, boasting powerful motors that ensure effective cutting and cleaning. Whether it’s mowing a lawn, trimming hedges, or blowing leaves, users can trust the Cobalt Series to deliver professional results.

Moreover, the Cobalt Series prioritizes safety, incorporating features like automatic shut-off and safety guards. These enhancements not only protect the user but also ensure that the equipment remains in top condition during operation.

In terms of maintenance, the Cobalt Series tools are designed to be hassle-free. Many models include self-cleaning mechanisms and robust components that require minimal upkeep. This focus on reliability means that gardeners can spend more time enjoying their outdoor spaces and less time on repairs.

Finally, with a sleek and modern aesthetic, the Simplicity Cobalt Series not only performs well but also looks great in any garden shed or workspace. Overall, the Cobalt Series is a testament to Simplicity’s dedication to combining innovation with practical gardening solutions. Whether you are rejuvenating your garden or maintaining a landscape, the tools from the Cobalt Series are sure to enhance your gardening experience.
Top Page Image Contents