Falcon 15 manual In & Out Settings Fm Version, 12.5SETTING THE SPLIT MODES

IN & OUT SETTINGS (FM VERSION) ENG

12.5SETTING THE SPLIT MODES

The MPX SPLIT mode allows Falcon 15 Output to toggle between an external MPX signal applied to AUX 1 input and the MPX signal internally generated (see Switch SW1 and SW2 here below). Switching is triggered by Input 1 on Digital Data Port (ref to par. 11.10).

NOTE: FALCON 15 - FM VERSION IS REQUIRED, WITH INSTALLED SPLIT OPTION (ref to Chapt. 2)

MPX SPLIT	data port	OUTPUT	LOGIC SWITCHERS
mode	INPUT1
			SW 1	SW 3
enabled	active	Internal Mpx	open	closed
	unactive	Fold-back of Aux 1 signal *	closed	open

Whenever the RDS option is also installed (ref to Section 2.1), RDS signal available on the Output with the Split Mode activated depends on the ‘RDS On Split’ function setting (see Table here below). In other words, RDS signal generated by Falcon 15 may be always available (even when the AUX signal is routed to the Output) or it may be removed.

RDS ON	data port	OUTPUT	LOGIC SWITCHERS
SPLIT mode	INPUT1
			Sw1	Sw2	Sw3
disabled	active	Internal Mpx + internal RDS	open	closed	closed
	unactive	Fold-back of Aux 1 signal *	closed	open	open
	active	Internal Mpx + internal RDS	open	closed	closed
enabled
	unactive	Fold-back of Aux 1 signal* + internal RDS	closed	closed	open

* Aux 1 level is controlled via trimmer (ref to par. 11.6)

Page 33