ACCESSING THE TARGET FROM THE PC | ENG | |
|
|
|
- The Output page includes the controls for the functions: MPX Output Level, Audio Output Level, Pre- emphasis, Noise Gate, Output Mode, Output Sync and Input Mode (Stereo/Mono). These controls may ba disabled, according to Yr Falcon 15 version (ST or FM).
-The Input page includes the controls for the functions: AGC Mode, AGC Speed, Input Sensibility and Input selection (analog or digital)
-The MPX page includes the controls for the functions: Pilot Phase and Pilot Level, MPX Mode. This page is disabled when operating the ST Falcon 15 version.
-The RDS submenu includes the programming windows for the RDS functions (ref. to the next Section)
NOTE: In each menu, any changes to the parameters may be saved by clicking the button ‘ok’, while clicking ‘Cancel’ allows you to abandon the changes (or the submenu) without saving.
17 ACCESSING THE TARGET FROM THE PC
Connect the Pc Com Port to one of the available Target serial ports.
Use a regular serial cables pin to pin type for connections (see par. 11.9). Cable lenght must not exceed 20 mt.
A serial connection (serial cable) between Host Pc Serial Port and one of the Falcon 15 serial ports IS REQUIRED. Connection link is always established in a bidirectional mode.
Always close the control program before removing the connection. In case the front panel operation freezes, switch off and then switch on the equipment and check Yr computer.
Please note that the Processor’s serial ports are enabled by default. To check their enabling or status control, please follow the steps indicated at par. 12.6.1.
Open the SETUP window on the pc software.
Page 54