3.Some models have gauge wheels on the mower deck. If equipped, remove the gauge wheels.
4.Move the deck lift lever to the LEVEL ADJUSTMENT position (Figure 35).
WARNING: The deck lift lever is spring loaded. Make sure the lift lever is locked in the LEVEL ADJUSTMENT position.
5.Loosen the left and right adjuster knobs (Figure 36). Push down on each side of the mower deck. Make sure both sides of the mower deck are setting on a flat surface. Also, make sure the lift links are loose and can easily move up or down.
6.Push down on the lift links and tighten the left and right adjuster knobs (Figure 36). Make sure the adjuster knobs are tight. If necessary, use a wrench to tighten the adjuster knobs. For plastic adjuster knobs, tighten to a torque of 7 foot pounds (9,5 Nm). For metal adjuster knobs, tighten to a torque of 10 foot pounds (13,5 Nm).
7.Raise the deck lift lever from the LEVEL ADJUSTMENT position to a CUTTING HEIGHT position (Figure 37).
8.If equipped, install the gauge wheels.
9.Mow for a short distance. If the height of cut is not level, repeat the above steps.
CAUTION: Do not operate with the mower deck in the LEVEL ADJUSTMENT position. If you operate in the LEVEL ADJUSTMENT position, the mower deck and blades can be damaged.
C |
A |
B |
Figure 35: Lever adjustment
A - Deck lift lever
B - LEVEL ADJUSTMENT positon
C - CUTTING HEIGHT positions
English
A |
B |
Figure 36: Loosening adjuster knobs
A - Lift link
B - Adjuster knobs
A |
B |
Figure 37: Cutting position
A - Deck lift lever
B - CUTTING HEIGHT positions
Replacing the Motion Drive Belt
The motion drive belt is designed for extremely long life, and with proper care and maintenance, it should last for the life of the unit. However, in the unlikely event that the motion drive belt should require replacement, it should be performed only by an authorized dealer.
en
33