Snapper LT23460AWS specifications Towing, Maintenance

Page 6

!

Important Operator Safety Instructions (Continued)

!

Towing

1.Tow only with a machine that has a hitch designed for towing. DO NOT attach towed equipment except at the hitch point.

2.Follow the manufacturer’s recommendation for weight limits for towed equipment and towing on slopes.

3.DO NOT allow children or others on towed equipment.

4.On slopes, the weight of the towed equipment may cause loss of traction and loss of control.

5.Travel slowly and allow extra distance to stop.

Maintenance

1.DO NOT store machine or fuel container inside where fumes may reach an open flame, spark or pilot light such as in a water heater, furnace, clothes dryer or other gas appliance. Allow engine to cool before storing machine in an enclosure. Store fuel container out of the reach of children in a well ventilated, unoccupied building.

2.Keep engine free of grass, leaves or excess grease to reduce fire hazard and engine overheating.

3.When draining fuel tank, drain fuel into an approved container outdoors and away from open flame.

4.Check brakes frequently; adjust, repair or replace as needed.

5.Keep all bolts, nuts and screws properly tight. Check that all cotter pins are in proper position.

Maintenance

(Continued From Previous Column)

6.Always provide adequate ventilation when running engine. Exhaust gases contain carbon monoxide, an odorless and deadly poison.

7.Disconnect negative (black) cable from battery before performing maintenance or service. Cranking engine could cause injury.

8.DO NOT work under machine without safety blocks.

9.Service engine and make adjustments only when engine is stopped. Remove spark plug wire(s) from spark plug(s) and secure wire(s) away from spark plug(s).

10.DO NOT change engine governor speed settings or overspeed engine.

11.Lubricate machine at intervals specified in manual to prevent controls from binding.

12.Mower blades are sharp and can cut. Wrap the blades or wear heavy leather gloves and use CAUTION when handling them.

13.DO NOT test for spark by grounding spark plug next to spark plug hole; spark plug could ignite gas exiting engine.

14.Have machine serviced by an authorized SNAPPER dealer at least once a year and have the dealer install any new safety devices.

15.Maintain or replace safety and instruction labels as necessary.

16.Use only genuine SNAPPER replacement parts to assure that original standards are maintained.

6

www.snapper.com

Image 6
Contents Lawn Tractor Series Manual No Rev. ‘-’, 2/18/2009Where to Find Us Mower EngineDate Purchased Table of Contents Preparation Protection for ChildrenProtection against Tipovers Do not allow pre-teenage children to operate machineSafe Handling of Gasoline OperationTowing International Pictorials GhijAssembly Parts Bag ContentsInstalling the Seat Assembling the Steering WheelMaintenance Free Battery How to Install the Battery CablesIMPORTANT! Before You Start Mowing Remove the protective cap from the battery terminalHow To Check The Safety Interlock Switches Operator Presence System SeatHow to Prepare the Engine Check the TiresCheck the Level of the Mower Deck Features and Controls Operation Using ControlsHow to Use the Throttle Control AttachmentsHow to Engage the Blades How to Use the Speed Control PedalDriving and Stopping the Unit How to Change Direction How to Use the Cruise ControlHow to Drive in Reverse How to Disconnect the TransmissionHow to Set the Parking Brake How to Change the Cutting HeightHow to Stop the Unit Remove the key to restrict access to the RMO feature How to Transport the UnitHow to Operate the Mower Deck MowingHow to Start Operation on a Hill How to Operate the Unit on HillsHow to Stop on a Hill All-Wheel SteeringBefore Starting the Engine Check the Oil How to Start the EngineEngine Operation Add GasolineMowing and Bagging Tips TipsOperating Tips Use the left side of the mower deck to trim near an objectFrequency Maintenance Required Comments MaintenanceMaintenance Schedule Maintenance engine Examine bladesGeneral Recommendations How to Check the MufflerHow to Remove and Install the Blade InspectionInstall the mower deck. See How To Install The Mower Deck How to Sharpen the BladeAdjustments How to Check and Adjust the PTO ClutchBlade Brake Check How to Check and Adjust the Motion Drive Belt Remove the 1/4 inch 6 mm pin or bolt FigureHow to Check and Adjust the Drive Brake Adjusting drive brake Drive brake Gearbox Hex nutHow to Clean the Battery How to Remove the BatteryLift the battery tray and the battery out of the unit How to Charge the BatteryWhere to Lubricate LubricationHow to Remove the Mower Deck Mower Deck MaintenanceHow to Check the Fuel Filter How to Install the Mower DeckHanger rod Q Adjuster arm Axle bolts for the gauge wheels were mounted How to Adjust the Gauge WheelsHow to Level the Mower Deck Remove the gauge wheels FigureLoosening adjuster knobs Lift link Adjuster knobs Replacing the Motion Drive BeltHow to Replace the Primary Mower Drive Belt How to Replace the Secondary Mower Drive BeltRemove the primary mower drive belt from the stack pulley English How to Install the Wheels Rear wheel assembly Valve stemWheel Alignment Remove the bolt or pin used in stepHow to Clean the Mower Deck How to Replace the FuseHow to Replace the Light Bulb Raise the tractor hoodStorage over 30 days Troubleshooting Troubleshooting ChartCut level Pedal is depressed When the brake pedal isCorrectly Mower blades will notSpecifications Product SpecificationsEnglish Page English Page Year Limited Warranty Snapper Products Macon Street McDonough, GA

LT23460AWS specifications

The Snapper LT23460AWS is a versatile riding lawn mower designed for homeowners seeking efficiency, comfort, and ease of use in maintaining their lawns. This model comes equipped with several innovative features and technologies that enhance its performance and user experience.

One of the standout characteristics of the LT23460AWS is its powerful 23 horsepower Briggs & Stratton engine. This engine provides ample power to tackle various terrains, ensuring a smooth and efficient mowing experience. The mower operates on a hydrostatic transmission system, allowing users to easily adjust the speed and direction without the need for manual shifting, making it ideal for navigating around obstacles with ease.

The Snapper LT23460AWS features a 60-inch cutting deck, which allows for wide coverage in fewer passes, reducing the time spent mowing. This cutting deck is equipped with a robust cutting system, designed to deliver a clean, precise cut, whether tackling tall grass or maintaining a manicured lawn. Additionally, the deck height can be easily adjusted to suit different grass lengths, providing flexibility in lawn care.

Comfort is a key aspect of the LT23460AWS. The mower is designed with a spacious, ergonomic seat that provides ample cushioning, allowing for hours of comfortable mowing. Its easy-to-reach controls are strategically placed, enhancing user convenience and minimizing fatigue. The steering wheel is designed for optimal maneuverability, making it easier to navigate tight corners and complex landscaping.

Another notable technology in the Snapper LT23460AWS is the Advanced Air Management System. This technology optimizes airflow within the cutting deck, ensuring even grass distribution and improving overall cut quality. Moreover, the mower includes a mulching capability, allowing homeowners to cut grass into fine pieces that can enrich the lawn when returned to the soil.

The LT23460AWS is also designed with durability in mind. Its robust construction features high-quality materials that can withstand the rigors of regular mowing. This commitment to durability ensures that the Snapper LT23460AWS will provide reliable performance season after season.

In summary, the Snapper LT23460AWS is a powerful and efficient riding mower that combines advanced technology with user-friendly design. With its powerful engine, hydrostatic transmission, and comfortable seating, this mower is poised to meet the diverse needs of homeowners while delivering high-quality lawn care results.