Snapper LT23460AWS specifications Mower Deck Maintenance, How to Check the Fuel Filter

Page 30

How to Check the Fuel Filter

NOTE: Before you replace the fuel filter or the fuel line, the fuel tank must be empty.

If the fuel filter is dirty, the engine will run rough and have less performance. Remove the old filter (Figure 29). Replace the old filter with a new filter. Use an original equipment part. See an authorized service dealer in your area.

A

B

B

A

C

Figure 29: Fuel filter

A - Fuel line

B - Clips

C - Fuel filter (example only)

Check the Tires

Check the air pressure in the tires. Tires with too much air pressure will cause the unit to ride rough. Also, the wrong air pressure will keep the mower deck from cutting level.

Recommended air pressure is 14 PSI (1 BAR) for both front and rear tires.

Mower Deck Maintenance

How to Remove the Mower Deck

1.Push the PTO switch down to the DISENGAGE position.

2.Open the deck level position cover, and move the deck lift lever to the level adjustment position (Figure 30).

WARNING: The deck lift lever is spring loaded. Make sure the deck lift lever is locked in the LEVEL ADJUSTMENT position.

3.Remove the hair pins and the washers from the adjuster arms (Figure 31). See illustrations “C” and “D”.

4.Remove the hair pins and washers from the suspension links. See illustrations “A” and “B”.

Figure 30: Deck lift lever

A - Deck level position cover (partially hidden) B - Deck level adjustment position

5.Disconnect the front hanger from the axle support. See illustration “E”.

6.Remove the mower drive belt from the clutch pulley. See illustration “F”.

7.Pull the mower deck away from the right side of the unit.

8.To operate without the mower deck, move the deck lift lever to the TOP position.

How to Install the Mower Deck

1.Push the mower deck under the right side of the unit.

2.Put the mower drive belt around the clutch pulley. Make sure the “V” side of the mower drive belt is against the clutch pulley. Also, make sure the mower drive belt is not twisted. See illustration “F”.

3.Attach the front hanger to the axle support with the hanger rod. Fasten with the fasteners as shown. See illustration “E”.

4.Make sure the mower drive belt is between the clutch pulley and the two belt guides. See illustration “F”.

5.Attach the suspension links to the lifter assembly. Fasten with the washers and hair pins. See illustrations “A” and “B”.

6.Attach the right and the left adjuster arms to the suspension brackets. Fasten with the washers and hair pins. See illustrations “C” and “D”.

7.Make sure the mower deck is level. See the instructions on “How To Level The Mower Deck”.

8.Check the operation of the PTO clutch. See the instructions on “How To Adjust The PTO Clutch”.

30

www.snapper.com

Image 30
Contents Lawn Tractor Series Manual No Rev. ‘-’, 2/18/2009Where to Find Us Mower EngineDate Purchased Table of Contents Preparation Protection for ChildrenProtection against Tipovers Do not allow pre-teenage children to operate machineSafe Handling of Gasoline OperationTowing International Pictorials GhijAssembly Parts Bag ContentsInstalling the Seat Assembling the Steering WheelMaintenance Free Battery How to Install the Battery CablesIMPORTANT! Before You Start Mowing Remove the protective cap from the battery terminalHow To Check The Safety Interlock Switches Operator Presence System SeatHow to Prepare the Engine Check the TiresCheck the Level of the Mower Deck Features and Controls Operation Using ControlsHow to Use the Throttle Control AttachmentsHow to Engage the Blades How to Use the Speed Control PedalDriving and Stopping the Unit How to Change Direction How to Use the Cruise ControlHow to Drive in Reverse How to Disconnect the TransmissionHow to Set the Parking Brake How to Change the Cutting HeightHow to Stop the Unit Remove the key to restrict access to the RMO feature How to Transport the UnitHow to Operate the Mower Deck MowingHow to Start Operation on a Hill How to Operate the Unit on HillsHow to Stop on a Hill All-Wheel SteeringBefore Starting the Engine Check the Oil How to Start the EngineEngine Operation Add GasolineMowing and Bagging Tips TipsOperating Tips Use the left side of the mower deck to trim near an objectFrequency Maintenance Required Comments MaintenanceMaintenance Schedule Maintenance engine Examine bladesGeneral Recommendations How to Check the MufflerHow to Remove and Install the Blade InspectionInstall the mower deck. See How To Install The Mower Deck How to Sharpen the BladeAdjustments How to Check and Adjust the PTO ClutchBlade Brake Check How to Check and Adjust the Motion Drive Belt Remove the 1/4 inch 6 mm pin or bolt FigureHow to Check and Adjust the Drive Brake Adjusting drive brake Drive brake Gearbox Hex nutHow to Clean the Battery How to Remove the BatteryLift the battery tray and the battery out of the unit How to Charge the BatteryWhere to Lubricate LubricationHow to Remove the Mower Deck Mower Deck MaintenanceHow to Check the Fuel Filter How to Install the Mower DeckHanger rod Q Adjuster arm Axle bolts for the gauge wheels were mounted How to Adjust the Gauge WheelsHow to Level the Mower Deck Remove the gauge wheels FigureLoosening adjuster knobs Lift link Adjuster knobs Replacing the Motion Drive BeltHow to Replace the Primary Mower Drive Belt How to Replace the Secondary Mower Drive BeltRemove the primary mower drive belt from the stack pulley English How to Install the Wheels Rear wheel assembly Valve stemWheel Alignment Remove the bolt or pin used in stepHow to Clean the Mower Deck How to Replace the FuseHow to Replace the Light Bulb Raise the tractor hoodStorage over 30 days Troubleshooting Troubleshooting ChartCut level Pedal is depressed When the brake pedal isCorrectly Mower blades will notSpecifications Product SpecificationsEnglish Page English Page Year Limited Warranty Snapper Products Macon Street McDonough, GA

LT23460AWS specifications

The Snapper LT23460AWS is a versatile riding lawn mower designed for homeowners seeking efficiency, comfort, and ease of use in maintaining their lawns. This model comes equipped with several innovative features and technologies that enhance its performance and user experience.

One of the standout characteristics of the LT23460AWS is its powerful 23 horsepower Briggs & Stratton engine. This engine provides ample power to tackle various terrains, ensuring a smooth and efficient mowing experience. The mower operates on a hydrostatic transmission system, allowing users to easily adjust the speed and direction without the need for manual shifting, making it ideal for navigating around obstacles with ease.

The Snapper LT23460AWS features a 60-inch cutting deck, which allows for wide coverage in fewer passes, reducing the time spent mowing. This cutting deck is equipped with a robust cutting system, designed to deliver a clean, precise cut, whether tackling tall grass or maintaining a manicured lawn. Additionally, the deck height can be easily adjusted to suit different grass lengths, providing flexibility in lawn care.

Comfort is a key aspect of the LT23460AWS. The mower is designed with a spacious, ergonomic seat that provides ample cushioning, allowing for hours of comfortable mowing. Its easy-to-reach controls are strategically placed, enhancing user convenience and minimizing fatigue. The steering wheel is designed for optimal maneuverability, making it easier to navigate tight corners and complex landscaping.

Another notable technology in the Snapper LT23460AWS is the Advanced Air Management System. This technology optimizes airflow within the cutting deck, ensuring even grass distribution and improving overall cut quality. Moreover, the mower includes a mulching capability, allowing homeowners to cut grass into fine pieces that can enrich the lawn when returned to the soil.

The LT23460AWS is also designed with durability in mind. Its robust construction features high-quality materials that can withstand the rigors of regular mowing. This commitment to durability ensures that the Snapper LT23460AWS will provide reliable performance season after season.

In summary, the Snapper LT23460AWS is a powerful and efficient riding mower that combines advanced technology with user-friendly design. With its powerful engine, hydrostatic transmission, and comfortable seating, this mower is poised to meet the diverse needs of homeowners while delivering high-quality lawn care results.