Snapper LT23460AWS specifications Safe Handling of Gasoline, Operation

Page 5

!

Important Operator Safety Instructions (Continued)

!

Protection against Tipovers

(Continued From Previous Column)

7.Keep people and pets out of mowing area. Immediately STOP blades, STOP engine, and STOP machine if anyone enters the area.

8.Check shields, deflectors, switches, blade controls and other safety devices frequently for proper operation and location.

9.Make sure all safety decals are clearly legible. Replace if damaged.

10.Protect yourself when mowing and wear safety glasses, a dust mask, long pants and substantial footwear.

11.Know how to STOP blades and engine quickly in preparation for emergencies.

12.Use extra care when loading or unloading the machine into a trailer or truck.

13.Check grass catcher components frequently for signs of wear or deterioration and replace as needed to prevent injury from thrown objects going through weak or worn spots.

Safe Handling of Gasoline

To avoid personal injury or property damage, use extreme care in handling gasoline. Gasoline is extremely flammable and the vapors are explosive.

1.Extinguish all cigarettes, cigars, pipes and other sources of ignition.

2.Use only an approved fuel container.

3.DO NOT remove fuel cap or add fuel with the engine running. Allow the engine to cool before refueling.

4.DO NOT refuel the machine indoors.

5.DO NOT store the machine or fuel container inside where there is an open flame, spark or pilot light such as on a water heater or other appliances.

6.DO NOT fill fuel containers inside a vehicle or on a truck or trailer bed with a plastic liner. Always place the containers on the ground away from the vehicle before filling.

7.Remove gas-powered equipment from the vehicle or trailer and refuel it on the ground. If this is not possible, then refuel equipment using a portable container, rather than a gasoline dispenser nozzle.

8.DO NOT start gas powered equipment in enclosed vehicles or trailers.

9.Keep the nozzle in contact with the rim of the fuel tank or container opening at all times until fueling is complete. DO NOT use a nozzle lock-open device

10.If fuel is spilled on clothing, change clothing immediately.

11.Never overfill a fuel tank. Replace fuel cap and tighten securely.

Operation

1.Mount and dismount machine from left side. Keep clear of discharge opening at all times.

2.Start engine from operator’s seat, if possible. Make sure blades are OFF and parking brake is set.

3.DO NOT leave machine with engine running. STOP engine, STOP blades, SET brake, and Remove key before leaving operators position of any reason.

4.DO NOT operate machine unless properly seated with feet on feet rests or pedal(s).

5.STOP BLADES and ENGINE and make sure blades have stopped before removing grass catcher or unclogging mower to prevent loss of fingers or hand.

6.Blades must be OFF except when cutting grass. Set blades in highest position when mowing over rough ground.

7.Keep hands and feet away from rotating blades underneath deck. DO NOT place foot on ground while BLADES are ON or machine is in motion.

8.DO NOT operate machine without entire grass catcher or guards in place and working. DO NOT point discharge at people, passing cars, windows or doors.

9.Slow down before turning.

10.Watch out for traffic when near or crossing roadways.

11.STOP engine immediately after striking an obstruction. Inspect machine and repair damage before resuming operation.

12.Operate machine only in daylight or with good artificial light.

13.Exercise CAUTION when pulling loads. Limit loads to those you can safely control and attach loads to hitch plate as specified with SNAPPER attachment instructions.

14.On slopes, the weight of the towed equipment may cause loss of traction and loss of control. When towing, travel slowly and allow extra distance to stop.

15.DO NOT operate engine in enclosed areas. Engine exhaust gases contain carbon monoxide, a deadly poison.

16.DO NOT discharge material against a wall or

obstruction. Material may ricochet back towards the operator.

17.Only use accessories approved by the manufacturer. See manufacturer’s instructions for proper operation and installation of accessories.

English

en

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Manual No Rev. ‘-’, 2/18/2009 Lawn Tractor SeriesDate Purchased Where to Find Us MowerEngine Table of Contents Protection against Tipovers Protection for ChildrenPreparation Do not allow pre-teenage children to operate machineOperation Safe Handling of GasolineTowing Ghij International PictorialsParts Bag Contents AssemblyAssembling the Steering Wheel Installing the SeatHow to Install the Battery Cables Maintenance Free BatteryHow To Check The Safety Interlock Switches Remove the protective cap from the battery terminalIMPORTANT! Before You Start Mowing Operator Presence System SeatCheck the Level of the Mower Deck How to Prepare the EngineCheck the Tires Features and Controls How to Use the Throttle Control Using ControlsOperation AttachmentsDriving and Stopping the Unit How to Engage the BladesHow to Use the Speed Control Pedal How to Drive in Reverse How to Use the Cruise ControlHow to Change Direction How to Disconnect the TransmissionHow to Stop the Unit How to Set the Parking BrakeHow to Change the Cutting Height How to Operate the Mower Deck How to Transport the UnitRemove the key to restrict access to the RMO feature MowingHow to Stop on a Hill How to Operate the Unit on HillsHow to Start Operation on a Hill All-Wheel SteeringEngine Operation How to Start the EngineBefore Starting the Engine Check the Oil Add GasolineOperating Tips TipsMowing and Bagging Tips Use the left side of the mower deck to trim near an objectMaintenance Schedule MaintenanceFrequency Maintenance Required Comments Maintenance engine Examine bladesHow to Remove and Install the Blade How to Check the MufflerGeneral Recommendations InspectionHow to Sharpen the Blade Install the mower deck. See How To Install The Mower DeckBlade Brake Check AdjustmentsHow to Check and Adjust the PTO Clutch Remove the 1/4 inch 6 mm pin or bolt Figure How to Check and Adjust the Motion Drive BeltAdjusting drive brake Drive brake Gearbox Hex nut How to Check and Adjust the Drive BrakeLift the battery tray and the battery out of the unit How to Remove the BatteryHow to Clean the Battery How to Charge the BatteryLubrication Where to LubricateHow to Check the Fuel Filter Mower Deck MaintenanceHow to Remove the Mower Deck How to Install the Mower DeckHanger rod Q Adjuster arm How to Level the Mower Deck How to Adjust the Gauge WheelsAxle bolts for the gauge wheels were mounted Remove the gauge wheels FigureReplacing the Motion Drive Belt Loosening adjuster knobs Lift link Adjuster knobsRemove the primary mower drive belt from the stack pulley How to Replace the Primary Mower Drive BeltHow to Replace the Secondary Mower Drive Belt English Rear wheel assembly Valve stem How to Install the WheelsRemove the bolt or pin used in step Wheel AlignmentHow to Replace the Light Bulb How to Replace the FuseHow to Clean the Mower Deck Raise the tractor hoodStorage over 30 days Troubleshooting Chart TroubleshootingCorrectly Pedal is depressed When the brake pedal isCut level Mower blades will notProduct Specifications SpecificationsEnglish Page English Page Year Limited Warranty Snapper Products Macon Street McDonough, GA

LT23460AWS specifications

The Snapper LT23460AWS is a versatile riding lawn mower designed for homeowners seeking efficiency, comfort, and ease of use in maintaining their lawns. This model comes equipped with several innovative features and technologies that enhance its performance and user experience.

One of the standout characteristics of the LT23460AWS is its powerful 23 horsepower Briggs & Stratton engine. This engine provides ample power to tackle various terrains, ensuring a smooth and efficient mowing experience. The mower operates on a hydrostatic transmission system, allowing users to easily adjust the speed and direction without the need for manual shifting, making it ideal for navigating around obstacles with ease.

The Snapper LT23460AWS features a 60-inch cutting deck, which allows for wide coverage in fewer passes, reducing the time spent mowing. This cutting deck is equipped with a robust cutting system, designed to deliver a clean, precise cut, whether tackling tall grass or maintaining a manicured lawn. Additionally, the deck height can be easily adjusted to suit different grass lengths, providing flexibility in lawn care.

Comfort is a key aspect of the LT23460AWS. The mower is designed with a spacious, ergonomic seat that provides ample cushioning, allowing for hours of comfortable mowing. Its easy-to-reach controls are strategically placed, enhancing user convenience and minimizing fatigue. The steering wheel is designed for optimal maneuverability, making it easier to navigate tight corners and complex landscaping.

Another notable technology in the Snapper LT23460AWS is the Advanced Air Management System. This technology optimizes airflow within the cutting deck, ensuring even grass distribution and improving overall cut quality. Moreover, the mower includes a mulching capability, allowing homeowners to cut grass into fine pieces that can enrich the lawn when returned to the soil.

The LT23460AWS is also designed with durability in mind. Its robust construction features high-quality materials that can withstand the rigors of regular mowing. This commitment to durability ensures that the Snapper LT23460AWS will provide reliable performance season after season.

In summary, the Snapper LT23460AWS is a powerful and efficient riding mower that combines advanced technology with user-friendly design. With its powerful engine, hydrostatic transmission, and comfortable seating, this mower is poised to meet the diverse needs of homeowners while delivering high-quality lawn care results.
Top Page Image Contents