Snapper LT23460AWS How to Remove the Battery, How to Clean the Battery, How to Charge the Battery

Page 28

Maintenance Free Battery

How to Remove the Battery

To charge or clean the battery, remove the battery from the unit as follows.

WARNING: To prevent sparks, disconnect the black battery cable from the negative (-) terminal before you disconnect the red cable.

WARNING: The battery contains sulfuric acid which is harmful to the skin, eyes, and clothing. If the acid gets on the body or clothing, wash with water.

1.Disconnect the black cable from the negative (-) terminal (Figure 27).

2.Disconnect the red cable from the positive (+) terminal.

3.Lift the battery tray and the battery out of the unit.

How to Clean the Battery

1.Remove the battery.

2.Wash the battery with a solution of one gallon of water and four tablespoons of baking soda (sodium bicarbonate). Make sure the solution does not get into the battery cells.

3.Clean the terminals and the ends of the cables with a wire brush.

4.Install the battery.

5.To prevent corrosion, apply grease to the battery terminals.

How to Charge the Battery

WARNING: When you charge the battery, do not smoke. Keep the battery away from any sparks. The fumes from the battery acid can cause an explosion.

1.Before you charge the battery, remove the battery.

2.To charge the battery, use a 12 volt battery charger. Charge at a rate of 6 amperes for 1 hour.

3.Install the battery.

WARNING: To prevent sparks, fasten the red cable to the positive (+) terminal before you connect the black cable.

4.Fasten the red cable and terminal cover (if equipped) to the positive (+) terminal with the fasteners as shown.

5.Fasten the black cable to the negative (-) terminal with the fasteners as shown (Figure 27).

D

E

C

A

B

 

 

F

A

 

H

G

Figure 27: Battery

A - Carriage bolt

B - Hex nut

C - Black cable

D - Positive (+) terminal

E - Red cable

F - Battery

G - Battery tray

H - Terminal cover

28

www.snapper.com

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Lawn Tractor Series Manual No Rev. ‘-’, 2/18/2009Engine Where to Find Us MowerDate Purchased Table of Contents Protection for Children Protection against TipoversPreparation Do not allow pre-teenage children to operate machineSafe Handling of Gasoline OperationTowing International Pictorials GhijAssembly Parts Bag ContentsInstalling the Seat Assembling the Steering WheelMaintenance Free Battery How to Install the Battery CablesRemove the protective cap from the battery terminal How To Check The Safety Interlock SwitchesIMPORTANT! Before You Start Mowing Operator Presence System SeatCheck the Tires How to Prepare the EngineCheck the Level of the Mower Deck Features and Controls Using Controls How to Use the Throttle ControlOperation AttachmentsHow to Use the Speed Control Pedal How to Engage the BladesDriving and Stopping the Unit How to Use the Cruise Control How to Drive in ReverseHow to Change Direction How to Disconnect the TransmissionHow to Change the Cutting Height How to Set the Parking BrakeHow to Stop the Unit How to Transport the Unit How to Operate the Mower DeckRemove the key to restrict access to the RMO feature MowingHow to Operate the Unit on Hills How to Stop on a HillHow to Start Operation on a Hill All-Wheel SteeringHow to Start the Engine Engine OperationBefore Starting the Engine Check the Oil Add GasolineTips Operating TipsMowing and Bagging Tips Use the left side of the mower deck to trim near an objectMaintenance Maintenance ScheduleFrequency Maintenance Required Comments Maintenance engine Examine bladesHow to Check the Muffler How to Remove and Install the BladeGeneral Recommendations InspectionInstall the mower deck. See How To Install The Mower Deck How to Sharpen the BladeHow to Check and Adjust the PTO Clutch AdjustmentsBlade Brake Check How to Check and Adjust the Motion Drive Belt Remove the 1/4 inch 6 mm pin or bolt FigureHow to Check and Adjust the Drive Brake Adjusting drive brake Drive brake Gearbox Hex nutHow to Remove the Battery Lift the battery tray and the battery out of the unitHow to Clean the Battery How to Charge the BatteryWhere to Lubricate LubricationMower Deck Maintenance How to Check the Fuel FilterHow to Remove the Mower Deck How to Install the Mower DeckHanger rod Q Adjuster arm How to Adjust the Gauge Wheels How to Level the Mower DeckAxle bolts for the gauge wheels were mounted Remove the gauge wheels FigureLoosening adjuster knobs Lift link Adjuster knobs Replacing the Motion Drive BeltHow to Replace the Secondary Mower Drive Belt How to Replace the Primary Mower Drive BeltRemove the primary mower drive belt from the stack pulley English How to Install the Wheels Rear wheel assembly Valve stemWheel Alignment Remove the bolt or pin used in stepHow to Replace the Fuse How to Replace the Light BulbHow to Clean the Mower Deck Raise the tractor hoodStorage over 30 days Troubleshooting Troubleshooting ChartPedal is depressed When the brake pedal is CorrectlyCut level Mower blades will notSpecifications Product SpecificationsEnglish Page English Page Year Limited Warranty Snapper Products Macon Street McDonough, GA

LT23460AWS specifications

The Snapper LT23460AWS is a versatile riding lawn mower designed for homeowners seeking efficiency, comfort, and ease of use in maintaining their lawns. This model comes equipped with several innovative features and technologies that enhance its performance and user experience.

One of the standout characteristics of the LT23460AWS is its powerful 23 horsepower Briggs & Stratton engine. This engine provides ample power to tackle various terrains, ensuring a smooth and efficient mowing experience. The mower operates on a hydrostatic transmission system, allowing users to easily adjust the speed and direction without the need for manual shifting, making it ideal for navigating around obstacles with ease.

The Snapper LT23460AWS features a 60-inch cutting deck, which allows for wide coverage in fewer passes, reducing the time spent mowing. This cutting deck is equipped with a robust cutting system, designed to deliver a clean, precise cut, whether tackling tall grass or maintaining a manicured lawn. Additionally, the deck height can be easily adjusted to suit different grass lengths, providing flexibility in lawn care.

Comfort is a key aspect of the LT23460AWS. The mower is designed with a spacious, ergonomic seat that provides ample cushioning, allowing for hours of comfortable mowing. Its easy-to-reach controls are strategically placed, enhancing user convenience and minimizing fatigue. The steering wheel is designed for optimal maneuverability, making it easier to navigate tight corners and complex landscaping.

Another notable technology in the Snapper LT23460AWS is the Advanced Air Management System. This technology optimizes airflow within the cutting deck, ensuring even grass distribution and improving overall cut quality. Moreover, the mower includes a mulching capability, allowing homeowners to cut grass into fine pieces that can enrich the lawn when returned to the soil.

The LT23460AWS is also designed with durability in mind. Its robust construction features high-quality materials that can withstand the rigors of regular mowing. This commitment to durability ensures that the Snapper LT23460AWS will provide reliable performance season after season.

In summary, the Snapper LT23460AWS is a powerful and efficient riding mower that combines advanced technology with user-friendly design. With its powerful engine, hydrostatic transmission, and comfortable seating, this mower is poised to meet the diverse needs of homeowners while delivering high-quality lawn care results.
Top Page Image Contents