Snapper G1000 Assembly, Before Starting Engine, Remove Generator From Carton, Carton Contents

Snapper G1000 Generator

ASSEMBLY

Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your generator, please call the generator helpline at

1-800-317-7833. If calling for assistance, please have the model, revision, and serial number from the data tag available.

Remove Generator From Carton

1.Set the carton on a rigid flat surface with “This Side Up” arrows pointing upward.

2.Carefully open the top flaps of the shipping carton.

3.Cut down corners at one end of carton from top to bottom and lay that side of carton down flat.

4.Remove all packing material, carton fillers, etc.

5.Remove the generator from the shipping carton.

BEFORE STARTING ENGINE

Add Engine Oil and Fuel

• Place generator on a level surface.

CAUTION

Any attempt to crank or start the engine before it has been properly filled with the recommended oil will result in equipment failure.

•Refer to engine manual for oil and fuel fill information.

•Damage to equipment resulting from failure to follow this instruction will void warranty.

•Refer to engine owner’s manual and follow oil and fuel recommendations and instructions.

NOTE: Check oil often during engine break–in. Refer to engine owner’s manual for recommendations.

NOTE: The generator assembly rotates on a prelubricated and sealed ball bearing that requires no additional lubrication for the life of the bearing.

Carton Contents

Check all contents. If any parts are missing or damaged, call the generator helpline at 1-800-317-7833. Shipped with your generator is:

•Main unit

•Owners manual

•Engine manual

•Battery charge cables

•Oil bottle

6