Cub Cadet 7252 manual Accessing the Engine Compartment, General Battery Information

Page 29

ACCESSING THE ENGINE COMPARTMENT

WARNING: If the tractor has been recently operated, engine surfaces (including the radiator) will be HOT. Allow the engine to cool before open- ing the hood, or use extreme caution to avoid burns when the hood is open.

To raise the hood, locate the latch release lever in the hood notch at the front of the tractor. Lift and hold the latch release lever while lifting the hood at the hood notch. See Figure 31.

HOOD

NOTCH

Lift Hood

LATCH

RELEASELift Lever

LEVER

Figure 31

To remove the two side panels:

Flip the tabs of the two quick release fasteners up and turn to align with the slots in the side panel. See Figure 32.

Slip the top of the side panel over and off the quick fastener tabs.

Lift the side panel straight upward and off of the retainer pins.

To reinstall the side panels:

Align the two holes in the bottom of the side panel with the retainer pins and slide the panel onto the pins. See Figure 32

Align the tabs of the quick release fasteners with the slots of the side panel and slip the panel over the tabs.

Pull the quick fastener tabs slightly outward and rotate 1/4 turn (perpendicular to slot) to lock the side panels in place. Flip the fastener tabs down.

QUICK FASTENER

Lift

Flip up

Turn

QUICK

FASTENER

SIDE

PANEL

RETAINER PINS

Figure 32

Close the hood by pushing downward until captured by the hood latch.

GENERAL BATTERY INFORMATION

WARNING:

Battery posts, terminals and related accesso- ries contain lead and lead compounds. Wash hands after handling.

Battery acid must be handled with great care, as contact with it can burn and blister the skin. It is advisable to wear protective clothing (goggles, rubber gloves and apron) when working with acid.

Should battery acid accidentally splatter into the eyes or onto the skin, rinse the affected area immediately with clean cold water. If there is any further discomfort, seek prompt medical attention.

If acid spills on clothing, first dilute it with clean water, then neutralize with a solution of ammonia/water or baking soda/water.

29

Image 29
Contents Operator’s Manual Important Read Safety Rules and Instructions CarefullyTo the Owner Table of ContentsCalling Service Information Rops Information Plate Recording Model and Serial Number InformationTractor Model Plate General Operation Important Safe Operation PracticesChildren Slope OperationOperating the PTO Do notService Safety Frame RopsStarting AID Safety LabelsFAN Warning Label Located on Each Side of Radiator Keep HandsRoll Over Warning Label Located on RIGHT/REAR Fender Battery Warning Label Located Under HoodPTO Warning Label Located on Rear PTO Shield Floorboard and Dash Panel Mounted Controls Controls and FeaturesIgnition Switch PTO SwitchSeat Adjustment Lever Steering WheelHeadlight Switch Hazard Light SwitchDifferential Lock Pedal Parking Brake LeverEngine Coolant Temperature Light Battery Indicator LightParking Brake Indicator Light PTO Indicator LightPTO Reverse Override Switch Fender Mounted Conrtols and FeaturesFuel Fill Cap PTO Selection LeverCup Holder Transmission Hi/Lo Range Shift LeverHand Holds Amber Hazard LightsOperation Safety Interlock SystemRollover Protective Structure Rops Fueling the TractorThrottle Handle Slow Fast PTO Switch ‘OFF’ Position NEW Tractor BREAK-IN ProceduresStarting the Engine Cold Weather StartingStopping the Engine Using Jumper Cables to Start the EngineDriving the Tractor Driving on SlopesStopping the Tractor Using the FORWARD/REVERSE PedalUsing the HI/LO Range Shift Lever Hydraulic Lift Lever Using the Differential Lock PedalUsing the Hydraulic Lift Lever Engaging the PTO Using the PTO Selection LeverUsing the Hitch Plate Using the PTO Reverse Override SwitchUsing the Three Point Hitch LightingFront Weights Tractor WeightingWeighting the Rear of the Tractor Rear Weight BoxAdjusting the Seat AdjustmentsAdjusting the Seat Belt Three Point Hitch AdjustmentsAdjustment Tube Adjusting Front Wheel TOE-INJAM NUT HEX Shaft HEX JAM NUTFeedback Links Rodhydraulic Lift Valve Adjusting the BrakesAdjusting Hydraulic Lift Feedback ROD Lubrication Table Tractor MaintenanceGeneral Information API11 5 Service Intervals Operation to Lubrication and Maintenance ChartGeneral Battery Information Accessing the Engine CompartmentBattery Maintenance Battery RemovalBattery Storage Battery Holddown ROD Wing NUT Holddown Strap Cable ClampTail Light Bulb Replacement Head Light Bulb ReplacementHazard Bulb Replacement Notch Lenses Bulb Socket Screw Inner Notch Housing OuterAccessing the Fuse Center Instrument Panel Bulb ReplacementServicing Electrical System Instrument Panel FusesChecking TRANSMISSION/HYDRAULIC System OIL Level Main FuseHazard Light Flasher Relay Transmission Drain Plug Changing TRANSMISSION/HYDRAULIC System OILHydrostatic Hydraulic System OIL Filter Initial Break-In Period Filter Change Tire Maintenance Maintenance of the Rollover Protective Structure RopsTire Inflation Chart Lubrication of Drive ShaftRemoving the Tractor from Storage Front of EngineTractor Storage Engine Information and Maintenance Limited Liability Cleaning the Engine Engine MaintenanceCleaning the Radiator Screen and Radiator Before servicingChanging the Engine OIL and Filter Adding Engine OILHEX Drain Cock Engine Valve Full Mark OIL Filter Coolant ADD Mark ReservoirRemote Radiator CAP Filler Neck Overflow Hose Checking Engine Coolant LevelInspection of Cooling System Hoses Changing the AIR CleanerChanging the Engine Coolant Overflow Reservoir Coolant Drain PlugServicing the Paper Element Servicing the Foam PrecleanerServicing the Spark Plugs Changing the Fuel FilterSpecifications General Dimensions Power Take-OffHydraulic Lift System BrakesModel Number Optional Equipment and AccessoriesDescription CLEVELAND, Ohio CUB Cadet LLC Post Office BOX

7252 specifications

The Cub Cadet 7252 is a noteworthy addition to the lineup of robust and reliable lawn tractors designed for residential homeowners and landscaping professionals alike. This model combines power, versatility, and advanced technology to deliver an exceptional mowing experience.

One of the standout features of the Cub Cadet 7252 is its powerful engine. It is equipped with a reliable, air-cooled Kohler engine, providing ample horsepower to tackle even the most demanding mowing tasks. This engine delivers smooth and consistent performance, ensuring that users can cut through thick grass and uneven terrain with ease. The hydrostatic transmission further enhances functionality by offering a seamless driving experience without the need for manual gear shifting.

The cutting deck of the Cub Cadet 7252 is another highlight. With a wide 50-inch cutting deck, it allows for efficient mowing over large areas, reducing the time spent on lawn maintenance. The deck features a reinforced steel construction for durability and longevity, capable of withstanding the rigors of regular use. Additionally, users can achieve different cutting heights with ease, thanks to the 12 position height adjustment feature, ranging from 1 to 4 inches.

Technologically, the 7252 model integrates innovative features for enhanced comfort and ease of use. The ergonomic high-back seat provides maximum support during extended mowing sessions, while the comprehensive dashboard displays essential information, such as fuel level and engine status, allowing for better operation management.

Furthermore, this lawn tractor is designed with user convenience in mind. It features a tight turning radius, which makes maneuvering around obstacles such as trees and flower beds incredibly easy. The Cub Cadet 7252 also offers optional attachments like baggers and snow blowers, making it a versatile tool for various seasonal tasks beyond lawn care.

Overall, the Cub Cadet 7252 is engineered for performance, comfort, and versatility. Combining a powerful engine, wide cutting deck, and innovative technologies, it serves as an excellent solution for homeowners looking to maintain their lawns efficiently while enjoying the convenience of modern machinery.