Cub Cadet 7252 manual Battery Removal, Battery Maintenance, Battery Storage

Page 30

Since battery acid is corrosive, do not pour it into any sink or drain. Before discarding an empty electrolyte container, rinse it thoroughly with a neutralizing solution.

NEVER connect (or disconnect) battery charger clips to the battery while the charger is turned on, as it can cause sparks.

Keep all sources of ignition (cigarettes, matches, lighters) away from the battery. The hydrogen gas generated during charging can be combustible.

As a further precaution, only charge the battery in a well ventilated area.

Always shield eyes and protect skin and clothing when working near batteries.

WARNING: Batteries contain sulfuric acid and may emit ex-plosive gases.

BATTERY

HOLDDOWN

ROD

WING NUT HOLDDOWN STRAP

CABLE

CLAMP

Use extreme caution when handling batteries. Keep batteries out of the reach of children.

BATTERY REMOVAL

WARNING: Battery posts, terminals and related accessories contain lead and lead compounds. Wash hands after handling.

The battery is located at the front of the tractor beneath the hood, just forward of the radiator.

To remove the battery:

Open the tractor hood as described in the previous sub-section.

Remove the two wing nuts and the battery holddown strap from the battery holddown rods. See Figure 33.

Loosen the negative battery cable clamp and disconnect the negative lead from the battery; then disconnect the positive lead from the battery.

Carefully lift the battery out of the tractor.

Install the battery by repeating the above steps in the reverse order.

WARNING: Always connect the posi- tive lead to the battery before con- necting the negative lead. Also make certain the cable clamps are posi- tioned so that they DO NOT contact the holddown strap.

Figure 33

BATTERY MAINTENANCE

The battery is filled with battery acid and then sealed at the factory. However, even a “maintenance free” battery requires some maintenance to ensure its proper life cycle.

Spray the terminals and exposed wire with a battery terminal sealer, or coat the terminals with a thin coat of grease or petroleum jelly, to protect against corrosion.

The battery should be kept clean. Any deposits of acid should be neutralized with baking soda and water. Be careful not to get this solution in the cells.

Avoid tipping. Even a sealed battery will leak electrolyte when tipped.

BATTERY STORAGE

When storing the tractor for extended periods, disconnect the battery cables. Removing the battery from the unit is recommended.

All batteries discharge during storage. Keep the exterior of the battery clean, especially the top. A dirty battery will discharge more rapidly.

The battery must be stored with a full charge. As the battery discharges, the electrolyte is weakened and will freeze at a higher temperature.

Recharge the battery before returning to service; or every two months, whichever comes first.

30

Image 30
Contents Important Read Safety Rules and Instructions Carefully Operator’s ManualTable of Contents Calling Service InformationTo the Owner Recording Model and Serial Number Information Tractor Model PlateRops Information Plate Important Safe Operation Practices General OperationOperating the PTO Slope OperationChildren Do notSafety Frame Rops ServiceFAN Warning Label Located on Each Side of Radiator Safety LabelsStarting AID Keep HandsBattery Warning Label Located Under Hood PTO Warning Label Located on Rear PTO ShieldRoll Over Warning Label Located on RIGHT/REAR Fender Controls and Features Floorboard and Dash Panel Mounted ControlsSeat Adjustment Lever PTO SwitchIgnition Switch Steering WheelDifferential Lock Pedal Hazard Light SwitchHeadlight Switch Parking Brake LeverParking Brake Indicator Light Battery Indicator LightEngine Coolant Temperature Light PTO Indicator LightFuel Fill Cap Fender Mounted Conrtols and FeaturesPTO Reverse Override Switch PTO Selection LeverHand Holds Transmission Hi/Lo Range Shift LeverCup Holder Amber Hazard LightsRollover Protective Structure Rops Safety Interlock SystemOperation Fueling the TractorStarting the Engine NEW Tractor BREAK-IN ProceduresThrottle Handle Slow Fast PTO Switch ‘OFF’ Position Cold Weather StartingDriving the Tractor Using Jumper Cables to Start the EngineStopping the Engine Driving on SlopesUsing the FORWARD/REVERSE Pedal Using the HI/LO Range Shift LeverStopping the Tractor Using the Differential Lock Pedal Using the Hydraulic Lift LeverHydraulic Lift Lever Using the PTO Selection Lever Engaging the PTOUsing the Three Point Hitch Using the PTO Reverse Override SwitchUsing the Hitch Plate LightingWeighting the Rear of the Tractor Tractor WeightingFront Weights Rear Weight BoxAdjusting the Seat Belt AdjustmentsAdjusting the Seat Three Point Hitch AdjustmentsJAM NUT Adjusting Front Wheel TOE-INAdjustment Tube HEX Shaft HEX JAM NUTAdjusting the Brakes Adjusting Hydraulic Lift Feedback RODFeedback Links Rodhydraulic Lift Valve General Information Tractor MaintenanceLubrication Table API11 5 Lubrication and Maintenance Chart Service Intervals Operation toAccessing the Engine Compartment General Battery InformationBattery Storage Battery RemovalBattery Maintenance Battery Holddown ROD Wing NUT Holddown Strap Cable ClampHazard Bulb Replacement Head Light Bulb ReplacementTail Light Bulb Replacement Notch Lenses Bulb Socket Screw Inner Notch Housing OuterServicing Electrical System Instrument Panel Bulb ReplacementAccessing the Fuse Center Instrument Panel FusesMain Fuse Hazard Light Flasher RelayChecking TRANSMISSION/HYDRAULIC System OIL Level Changing TRANSMISSION/HYDRAULIC System OIL Hydrostatic Hydraulic System OIL FilterTransmission Drain Plug Initial Break-In Period Filter Change Tire Inflation Chart Maintenance of the Rollover Protective Structure RopsTire Maintenance Lubrication of Drive ShaftFront of Engine Tractor StorageRemoving the Tractor from Storage Engine Information and Maintenance Limited Liability Cleaning the Radiator Screen and Radiator Engine MaintenanceCleaning the Engine Before servicingHEX Drain Cock Engine Valve Adding Engine OILChanging the Engine OIL and Filter Full Mark OIL Filter Coolant ADD Mark ReservoirChecking Engine Coolant Level Remote Radiator CAP Filler Neck Overflow HoseChanging the Engine Coolant Changing the AIR CleanerInspection of Cooling System Hoses Overflow Reservoir Coolant Drain PlugServicing the Spark Plugs Servicing the Foam PrecleanerServicing the Paper Element Changing the Fuel FilterSpecifications Hydraulic Lift System Power Take-OffGeneral Dimensions BrakesOptional Equipment and Accessories DescriptionModel Number CUB Cadet LLC Post Office BOX CLEVELAND, Ohio

7252 specifications

The Cub Cadet 7252 is a noteworthy addition to the lineup of robust and reliable lawn tractors designed for residential homeowners and landscaping professionals alike. This model combines power, versatility, and advanced technology to deliver an exceptional mowing experience.

One of the standout features of the Cub Cadet 7252 is its powerful engine. It is equipped with a reliable, air-cooled Kohler engine, providing ample horsepower to tackle even the most demanding mowing tasks. This engine delivers smooth and consistent performance, ensuring that users can cut through thick grass and uneven terrain with ease. The hydrostatic transmission further enhances functionality by offering a seamless driving experience without the need for manual gear shifting.

The cutting deck of the Cub Cadet 7252 is another highlight. With a wide 50-inch cutting deck, it allows for efficient mowing over large areas, reducing the time spent on lawn maintenance. The deck features a reinforced steel construction for durability and longevity, capable of withstanding the rigors of regular use. Additionally, users can achieve different cutting heights with ease, thanks to the 12 position height adjustment feature, ranging from 1 to 4 inches.

Technologically, the 7252 model integrates innovative features for enhanced comfort and ease of use. The ergonomic high-back seat provides maximum support during extended mowing sessions, while the comprehensive dashboard displays essential information, such as fuel level and engine status, allowing for better operation management.

Furthermore, this lawn tractor is designed with user convenience in mind. It features a tight turning radius, which makes maneuvering around obstacles such as trees and flower beds incredibly easy. The Cub Cadet 7252 also offers optional attachments like baggers and snow blowers, making it a versatile tool for various seasonal tasks beyond lawn care.

Overall, the Cub Cadet 7252 is engineered for performance, comfort, and versatility. Combining a powerful engine, wide cutting deck, and innovative technologies, it serves as an excellent solution for homeowners looking to maintain their lawns efficiently while enjoying the convenience of modern machinery.